The formation of lithiophobic inorganic solid electrolyte interphase (SEI) on Li anode and cathode electrolyte interphase (CEI) on the cathode is beneficial for high‐voltage Li metal batteries. However, in most liquid electrolytes, the decomposition of organic solvents inevitably forms organic components in the SEI and CEI. In addition, organic solvents often pose substantial safety risks due to their high volatility and flammability. Herein, an organic‐solvent‐free eutectic electrolyte based on low‐melting alkali perfluorinated‐sulfonimide salts is reported. The exclusive anion reduction on Li anode surface results in an inorganic, LiF‐rich SEI with high capability to suppress Li dendrite, as evidenced by the high Li plating/stripping CE of 99.4% at 0.5 mA cm−2 and 1.0 mAh cm−2, and 200‐cycle lifespan of full LiNi0.8Co0.15Al0.05O2 (2.0 mAh cm−2) || Li (20 µm) cells at 80 °C. The proposed eutectic electrolyte is promising for ultrasafe and high‐energy Li metal batteries.
1 April 2022 in Journal of the Electrochemical Society
An electrolyte consisting of lithium nitrate (LiNO3) and lithium difluoro(oxalato)borate (LiDFOB) in ethylene carbonate (EC), ethylmethyl carbonate (EMC), and triethyl phosphate (TEP) is used to improve the long-term cycling stability of silicon anodes. TEP was selected for its ability to dissolve LiNO3 in carbonates to a concentration of ∼0.2 M. The large amount of LiNO3 combined with the LiDFOB salt leads to a capacity retention of 87.1% after one hundred cycles due to the formation of a relatively stable solid electrolyte interphase (SEI). Ex-situ surface analysis reveals that the SEI consists of oxalates, lithium alkyl carbonates, borates, and nitrate reduction products. By selecting two components which are preferentially reduced (LiNO3 and LiDFOB), the SEI is able to inhibit continuous solvent decomposition and allows for improved electrochemical cycling for pure silicon anodes.
24 October 2022 in Journal of the Electrochemical Society
An investigation of alternative lithium salts, lithium tetrafluoroborate (LiBF4), lithium difluoro(oxalato)borate (LiDFOB) and lithium hexafluorophosphate (LiPF6), in novel ester-based (methyl acetate/fluoroethylene carbonate- MA/FEC or methyl propionate/fluoroethylene carbonate- MP/FEC) electrolyte formulations has been conducted in LiNi0.6Co0.2Mn0.2O2 (NCM622)/graphite cells to improve low temperature cycling performance of lithium ion batteries at −20 °C. Improved low temperature performance was observed with all the lithium salts in MA/FEC electrolyte while comparable room temperature (25 °C) capacities were observed with LiPF6 salt only. Detailed ex-situ analysis of surface films generated with LiBF4, LiDFOB and LiPF6 in ester-based electrolytes reveals that the solid electrolyte interphase (SEI) is predominately composed of lithium salt decompaction products and addition of 10% FEC (by volume%) may not be sufficient at forming a protective SEI.
1 June 2022 in Journal of the Electrochemical Society
Cycling lithiated metal oxides to high potential (>4.5 V vs Li) is of significant interest for the next generation of lithium ion batteries as this significantly increases the capacity and energy of cells. However, cells cycled to high potential suffer from rapid capacity fade due to a combination of thickening of the anode solid electrolyte interphase (SEI) and impedance growth on the cathode. While transition metal catalysed degradation of the anode SEI has been widely proposed as a primary source of capacity loss, a related acid induced degradation of the anode SEI is proposed. A systematic investigation of LiNi0.5Co0.2Mn0.3O2, and LiNi0.8Co0.1Mn0.1O2 cathodes cycled to 4.2 and 4.6 V has been conducted and the oxidative generation of the strong acid difluorophosphoric acid (F2PO2H) has been quantified by solution Nuclear Magnetic Resonance (NMR) spectroscopy. Ex-situ surface analysis of the electrodes with X-ray Photo Electron spectroscopy (XPS) suggests that the generation of F2PO2H correlates with a thickening of the anode SEI and an increase in the fluorophosphate content of the SEI. Changes to the LiNi0.8Co0.1Mn0.1O2 surface for cells cycled to 4.6 V are also consistent with the generation of acidic species. There is good correlation between the concentration F2PO2H, anode SEI degradation and the capacity loss of the cells.
1 March 2022 in Journal of the Electrochemical Society
The use of methyl acetate (MA) and methyl propionate (MP) as co-solvents in carbonate/LiPF6 electrolytes have been investigated in LiNi0.5Co0.2Mn0.3O2 (NCM523)/graphite cells to improve electrochemical performance at low temperature (−20 °C). Consistent with previous investigations, improved low temperature performance was observed with all electrolyte formulations containing esters. Detailed ex situ surface analysis of the surface films generated with the ester-based electrolytes containing electrolyte additives reveal significant changes to the SEI on graphite upon cycling at moderately elevated temperature (45 °C). In the presence of vinylene carbonate (VC) lithium plating is observed upon cycling at low temperature (−20 °C) which leads to a thicker solid electrolyte interface (SEI) upon cycling at 45 °C. Incorporation of fluoroethylene carbonate (FEC) as an electrolyte additive results in the generation of a thin SEI and alters the structure of the surface film on the NCM523 cathode resulting in stable cycling over a wide temperature range.
1 June 2023 in Journal of the Electrochemical Society
Three different organic solvents (dimethylacetamide (DMAc), dimethylformamide (DMF), and dimethyl sulfoxide (DMSO)) were used to improve the solubility of LiNO3 in a standard carbonate-based electrolyte with lithium difluoro(oxalato)borate (LiDFOB) as the salt. Together, the LiDFOB and organic-solvent solubilized LiNO3 preferentially reduce on the surface of silicon-containing anodes to create an SEI rich in oxalates, nitrate decomposition species, and B-F species. The improved stability of the SEI throughout the first 100 cycles results in silicon and silicon/graphite composite anodes with better capacity retention than observed with standard electrolytes or fluoroethylene carbonate (FEC) containing electrolytes. This study demonstrates the feasibility of the use of non-traditional electrolyte solvents in the improvement and optimization of lithium ion-battery electrolytes.