Bertan Bakkaloglu

Bertan Bakkaloglu

Auto-generated profile, based on publicly available information

Bertan Bakkaloglu

Arizona State University, Tempe, AZ, USA

Research Focus & Metrics

Academic Career Length

22Years (2005-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
4 December 2017 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
SASeyyed Amir Ayati
Seyyed Amir Ayati
DMDebashis Mandal
Debashis Mandal
BBBertan Bakkaloglu
Bertan Bakkaloglu
SKSayfe Kiaei
Sayfe Kiaei
An integrated reconfigurable CMOS quasi-circulator operating at 2.4 GHz is presented. A passive structure delivers transmit power amplifier (PA) output signal to the differential low-noise amplifier (LNA) input as a common-mode signal and simultaneously delivers received signal as a differential-mode signal at the LNA input. The leakage of the PA output signal at the LNA input is reduced in two steps. First, the use of a reconfigurable impedance matching circuit, instead of a fixed 50-Ω resistance reduces the leakage by compensating the antenna impedance mismatch, and improves transmitter-receiver isolation. Second, a reconfigurable summing stage adds amplitude and phase adjusted PA output signal to LNA output to cancel the residual PA output leakage. Measurement results show that the receiver achieves a reduction of 90 dB for a single tone and more than 50 dB for a QPSK modulated 40-MHz bandwidth transmit signal. The receiver gain is more than 10 dB and the noise figure in the receiver path is 4.5 dB. The reconfigurable quasi-circulator along with the receiver LNA is designed and fabricated on a 130-nm CMOS technology. The cancellation circuitry occupies 0.27 mm² and consumes 30-mW quiescent power, while the total active area of the chip is 1 mm², and it consumes 65-mW power.

19 December 2006 in IEEE Transactions on Nuclear Science
Verified
Journal Article
Closed access
WCW. Chen
W. Chen
VPV. Pouget
V. Pouget
GGG. K. Gentry
G. K. Gentry
HBH. J. Barnaby
H. J. Barnaby
BVB. Vermeire
B. Vermeire
PFP. Fouillat
P. Fouillat
Two important RF building blocks, a low noise amplifier and a voltage-controlled oscillator, were designed and fabricated in a 0.13 mum CMOS process using radiation-hardened by design techniques. Both circuits exhibit only minimal degradation with total dose when the parts are irradiated up to 500 krad (SiO2). Laser beam testing results indicate that the output spectrum of the two circuits has no noticeable change with laser energy up to 200 pJ

11 April 2011 in Analog Integrated Circuits and Signal Processing
Verified
Journal Article
Closed access
PDF file
HKHyuntae Kim
Hyuntae Kim
BKBharatan Konnanath
Bharatan Konnanath
Prasanna SattigeriPrasanna Sattigeri
Prasanna Sattigeri
Joseph WangJoseph Wang
Joseph Wang
Ashok MulchandaniAshok Mulchandani
Ashok Mulchandani
BBBertan Bakkaloglu
Bertan Bakkaloglu

2 December 2008 in Analog Integrated Circuits and Signal Processing
Verified
Journal Article
Closed access
PDF file
FCFeng Chen
Feng Chen
BBBertan Bakkaloglu
Bertan Bakkaloglu
SRSrinath Ramaswamy
Srinath Ramaswamy

18 February 2009 in Journal of Micromechanics and Microengineering
Verified
Journal Article
Closed access
SJSang-Soo Je
Sang-Soo Je
JHJere C Harrison
Jere C Harrison
MKMichael N Kozicki
Michael N Kozicki
BBBertan Bakkaloglu
Bertan Bakkaloglu
SKSayfe Kiaei
Sayfe Kiaei
JCJunseok Chae
Junseok Chae
This paper presents a new method for in situ tuning of acoustic sensitivity in micro-electro-mechanical-system (MEMS) microphones using silver metallic nano-electrodeposits. The nano-electrodeposits are electrochemically formed using an external dc bias under low power and at room temperature on an Ag-doped Ge30Se70 solid electrolyte film integrated with the microphone diaphragm. The growth/retraction mechanism generates mass/stress redistribution on the diaphragm and this effect is used to manipulate microphone sensitivity to incoming acoustic waves. Acoustic measurements with a reference microspeaker demonstrate that the microphone can achieve a tuning range of 0.6 dB (7.2%). This technique is useful for a variety of microdevice applications, including sensitivity matching for directional microphones (e.g., in hearing aids), post-package trimming and resonant frequency tuning.

1 November 2011
Verified
Conference Paper
Open access
SKSungho Kim
Sungho Kim
WLWilliam Lepkowski
William Lepkowski
SWSeth J. Wilk
Seth J. Wilk
TTTrevor J. Thornton
Trevor J. Thornton
BBBertan Bakkaloglu
Bertan Bakkaloglu
A CMOS low-power transceiver for implantable and external health monitoring devices operating in the MICS band is presented. The LNA core has an integrated mixer in a folded configuration to reuse the bias current, allowing high linearity with a low power supply levels. The baseband strip consists of a pseudo differential MOS-C band-pass filter achieving demodulation of 150kHz-offset BFSK signals. An all digital frequency-locked loop is used for LO generation in the RX mode and for driving a class AB power amplifier in the TX mode. The MICS transceiver is designed and fabricated in a 0.18μm 1-poly, 6-metal CMOS process. The sensitivities of -70dBm and -98dBm were achieved with NF of 40dB and 11dB at the data rate of 100kb/s while consuming only 600μW and 1.5mW at 1.2V and 1.8V, respectively. The BERs are less than 10 -3 at the input powers of -70dBm at 1.2V and -98dBm at 1.8V at the data rate of 100kb/s. Finally, the output power of the transmitter is 0dBm for a power consumption of 1.8mW.