The interaction of water with a magnetron-sputtered nickel oxide thin film on an n-type silicon photoanode is investigated in perspective to oxygen evolution. The substrate was exposed in-situ stepwise to gas phase water up to 10 L at liquid N2 temperature and analyzed via X-ray and UV photoelectron spectroscopy in the so called frozen electrolyte approach. Photoemission of the pristine NiOx layer shows the presence of stoichiometric NiO and Ni2O3 as well as of non-stoichiometric phases. In the monolayer range, molecular and dissociative adsorption is detected assigned to the NiO respective Ni2O3 phase. Initially, the emission of the molecular adsorbed water species interacting with NiO is found at 0.8 eV lower binding energies as compared to water related emission for higher coverages with binding energies commonly assigned to H2O-H2O interaction. In addition to the chemical analysis, the electronic structure of the n-Si/SiOx/NiOx/H2O photoanode is measured and discussed.
The interaction between (001) n-Si and NiOx was investigated with regard to the oxygen evolution reaction (OER), applicable either for water splitting or CO2 reduction. Thin layers of nickel oxide were deposited step by step by reactive sputter deposition and analyzed in-situ after each step using X-ray photoelectron spectroscopy (XPS). This was performed for silicon with different surface preparations: H-termination, thermally grown oxide (2 Å) and a monolayer of native oxide (4 Å). Upon contact formation the initial flatband like situation in the Si substrates changed to a 0.35 to 0.4 eV upward band bending for all three heterojunctions, with an alignment of the valence bands favorable to hole extraction. With near identical heterojunction performance and identical NiOx catalyst layers (η(10 mA/cm2) = 0.44 ± 0.01 V vs. RHE on Ni) an equally identical performance for the OER would be expected. While the native oxide covered sample shows the expected performance in cyclic voltammetry measurements the others fall short of expectations. Using chopped light measurements, this under-performance could be attributed to a higher density of defect states at the silicon surface. Apparently a 4Å SiO2 layer is sufficient protection to prevent the formation of defect states during NiOx deposition, thinner protective layers or none at all result in increased defect states, while thicker layers perform poorly due to their high resistance.
The (100) p-Si | n+-Si | Cu interface is investigated with respect to the electronic band structure and the electrochemical performance. Thin layers of metallic copper were deposited stepwise by E-beam deposition and analyzed in-line by XPS after each deposition step. For this purpose, different silicon surface terminations were prepared: hydrogen termination, thermal oxide (7 Å) and native oxide (3 Å). After contact formation the initial flatband situation of the n+-Si layer changes to an upward band bending depending on the Si surface termination: 0.45 eV for the H termination, 0.35 eV for the native oxide and 0.27 eV for the thermal oxide. The electrochemical performance measured by cyclic voltammetry for each junction correlates to the respective energy band alignment. While the H terminated surface with the highest upward band bending leads to the worst electrochemical performance, the surface passivated with thermal oxide and the lowest upward band bending results in the best electrochemical performance. For the two passivated surfaces, the thickness of the passivating oxide layer may also be an issue. The Si surface with a thicker thermal oxide (7 Å) shows better band alignment and electrochemical performance compared to the Si surface with a thinner native oxide (3 Å).