Apertures and slots of the enclosures come into prominence for heat allocation, ventilation, I/O cable, etc. These slots and apertures induce the coupling route of electromagnetic interference (EMI) from the inside to outside. So, electromagnetic shielding is usually used to decrease the emissions or to the progress of equipment immunity. In this paper, an effect of an aperture shape on the performance of electrical shielding effectiveness has been investigated by means of simulation. Rectangular, square, circular, equilateral triangle and hexagonal shape apertures that have a constant area of 5625 mm2 have been studied in addition to polarization type of applied electromagnetic field. It has been observed that ESE depends on the electric field direction and plane wave polarization and rectangular shape aperture has more effective ESE performance than square, circular, equilateral triangle and hexagonal type apertures. Rectangular shaped aperture has approximately 43 dB better performance than equilateral triangle one for whole frequency band of 100 MHz to 1GHz. Rectangular, square, circular, hexagonal and equilateral triangle type apertures have been ranked from best performance to the worst with respect to their ESE. There have been considerable findings that can be useful for enclosure designers about the effect of angle of incidence and polarization angle.
1 May 2018 in AEU - International Journal of Electronics and Communications
In order to exploit the use of remote sensing, microwave heating/drying and water stress in the agricultural sector, it is necessary to determine the dielectric properties of plant materials (branches, leaves, roots, fruits). In this way, the yield and quality of agricultural products can be increased. In this study, dielectric parameters of the sweet cherry and sour cherry leaves are measured by waveguide transmission line Method. The dielectric properties of the leaves (varying moisture content) are measured over a frequency ranging from (3.30–7.05 GHz) using WR229 (3.30–4.90 GHz) and WR159 (4.90–7.05 GHz) waveguide structures. A novel curve fitting technique is used to characterize dielectric properties of sweet cherry leaves. In order to verify the accuracy of the model the data obtained using this methodology is compared with measurement data of sour cherry leaves belonging to the same family. The determination coefficient R2 of the model for WR229 and WR159 are 0.996 and 0.998, respectively. Similarly, the Root Mean Square Error (RMSE) values of the model for WR229 and WR159 are 0.852 and 0.236, respectively.
11 September 2020 in IEEE Transactions on Electromagnetic Compatibility
In this article, the type of heatsinks and the horizontal/vertical orientation of them on the printed circuit boards are investigated to reduce electromagnetic interference (EMI) effects caused by the heatsink on the electronic components on the mainboard. The circular, rectangular, and square heatsinks with the equal base area are designed, simulated, and measured in the 1–10 GHz band. All parameters such as the reflection coefficient, electric field values, and radiation pattern are obtained and compared with each other to specify both selection priority of heatsink type and its orientation in a certain frequency range. As a novelty, both the effect of heatsink type and its orientation on EMI performance is investigated to prepare a heatsink selection handout by using simulation and measurement results. While the radiation emission (RE) of the circular type is the lowest between 1.8–3.6 and 5.8–7.8 GHz bands, the RE of the rectangular one is the lowest in 3.6–5.8 and 9.2–10 GHz. Also, for 1–10 GHz range, horizontal orientation is preferred for 10% of the whole frequency region, while vertical orientation is better for 24% regardless of the heatsink type.
8 May 2020 in Turkish Journal of Electrical Engineering and Computer Sciences