19 July 2015 in The International Journal of Advanced Manufacturing Technology
6 September 2021 in Polymer Composites
27 September 2015 in SAE International Journal of Advances and Current Practices in Mobility
The present work presents evaluation of the sliding surface morphology of brake pads during stick-slip. A low-metallic (LM) and a Non Asbestos Organic (NAO) brake friction materials were subjected to slide against a brake disc under conditions favorable to produce stick-slip phenomenon. The experiments were conducted in a laboratory-scale tribometer, which was especially designed to test brake pads used in vehicle. Delta torque divided by slip time (dT/dtslip) was the parameter used to quantify stick-slip propensity. In addition, optical microscope images of the material's surface were obtained at different stages of the braking test. These images were post-processed in appropriate computational software and by means of the segmentation technique, the real contact area, size and amount of contact plateaus related to the brake pad surface were estimated. This technique was effective to quantify the differences in the sliding surface morphology during low speed braking test. Finally, some trends related to the surface morphology of the brake pads selected in this study are shown as well as the relationship between both the material stick-slip behavior and morphological parameters is established and discussed.
5 November 2025 in Polymer Composites
In recent years, additive manufacturing, especially 3D printing, has been gaining more space in the production of parts and components in various industries. Among the polymer materials, polylactic acid (PLA) stands out due to its renewable sources, such as corn starch or sugar cane. This study focused on the evaluation of the coefficient of friction (CoF) and wear resistance of pins of pure PLA, pure thermoplastic polyurethane (TPU), and bronze‐filled PLA (BRO), all produced by fused deposition modeling (FDM). The pins were rubbed against a SAE 1020 steel counterpart in a pin‐on‐disc apparatus. The wear tests also included combinations of BRO/PLA and TPU/PLA (with a pattern on the surface), combined at three different percentages (25%, 50%, and 75%). Pure BRO showed the lowest wear rate ( K ≈0.9 × 10 −5 mm 3 /N m), while pure PLA exhibited the lowest CoF among the pins ( μ ≈0.24) but the highest wear ( K ≈16.7 × 10 −4 mm 3 /N m). The combination of 75% of BRO with 25% of PLA demonstrated a favorable balance between friction and wear, with a wear resistance close to BRO ( K ≈0.8 × 10 −5 mm 3 /N m) and a CoF similar to pure PLA ( μ ≈0.28). The paper extensively discusses the wear mechanisms observed on the worn surfaces, as well as the tribofilm formed on the steel disc counterpart.
21 November 2019 in Materials Research Express
This work investigates the potential use of Brazilian native Curauá fibre for friction purposes. The Curauá/unsaturated polyester composite, with untreated and NaOH-treated fibre, produced via resin transfer moulding and characterised using an air jet erosion tester and a lab-scale tribometer. Experiment parameters are different for each experiment. The applied loads at lab scale tribometer test are 100, 200 and 300 N, and ten repetitions performed for each load step. The coefficient of friction calculated, and the worn surfaces characterised through a stereoscope and scanning electron microscope (SEM). The coefficient of friction of the treated Curauá composite is higher than of the untreated one, and SEM and optical images revealed the wear mechanisms and helped to justify the friction results. Erosion response of fabricated composites characterised by adopting the design of experiments. Erodent impinging angle, velocity and flowrate are taken as measures. Worn studies reveal the mechanism of wear.