Aleksandra Marsh

Aleksandra Marsh

Auto-generated profile, based on publicly available information

Aleksandra Marsh

School of Chemistry, University of Bristol, Bristol, BS8 1TS, UK

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 January 2018 in Atmospheric Measurement Techniques
Verified
Journal Article
Open access
PDF file
UKUlrich K. Krieger
Ulrich K. Krieger
FSFranziska Siegrist
Franziska Siegrist
CMClaudia Marcolli
Claudia Marcolli
EEEva U. Emanuelsson
Eva U. Emanuelsson
FGFreya M. Gøbel
Freya M. Gøbel
DTDavid O. Topping
David O. Topping
To predict atmospheric partitioning of organic compounds between gas and aerosol particle phase based on explicit models for gas phase chemistry, saturation vapor pressures of the compounds need to be estimated. Estimation methods based on functional group contributions require training sets of compounds with well-established saturation vapor pressures. However, vapor pressures of semivolatile and low-volatility organic molecules at atmospheric temperatures reported in the literature often differ by several orders of magnitude between measurement techniques. These discrepancies exceed the stated uncertainty of each technique which is generally reported to be smaller than a factor of 2. At present, there is no general reference technique for measuring saturation vapor pressures of atmospherically relevant compounds with low vapor pressures at atmospheric temperatures. To address this problem, we measured vapor pressures with different techniques over a wide temperature range for intercomparison and to establish a reliable training set. We determined saturation vapor pressures for the homologous series of polyethylene glycols (H − (O − CH2 − CH2)n − OH) for n = 3 to n = 8 ranging in vapor pressure at 298 K from 10−7 to 5×10−2 Pa and compare them with quantum chemistry calculations. Such a homologous series provides a reference set that covers several orders of magnitude in saturation vapor pressure, allowing a critical assessment of the lower limits of detection of vapor pressures for the different techniques as well as permitting the identification of potential sources of systematic error. Also, internal consistency within the series allows outlying data to be rejected more easily. Most of the measured vapor pressures agreed within the stated uncertainty range. Deviations mostly occurred for vapor pressure values approaching the lower detection limit of a technique. The good agreement between the measurement techniques (some of which are sensitive to the mass accommodation coefficient and some not) suggests that the mass accommodation coefficients of the studied compounds are close to unity. The quantum chemistry calculations were about 1 order of magnitude higher than the measurements. We find that extrapolation of vapor pressures from elevated to atmospheric temperatures is permissible over a range of about 100 K for these compounds, suggesting that measurements should be performed best at temperatures yielding the highest-accuracy data, allowing subsequent extrapolation to atmospheric temperatures.

3 May 2017 in Atmospheric Chemistry and Physics
Verified
Journal Article
Open access
PDF file
AMAleksandra Marsh
Aleksandra Marsh
RMRachael E. H. Miles
Rachael E. H. Miles
GRGrazia Rovelli
Grazia Rovelli
ACAlexander G. Cowling
Alexander G. Cowling
LNLucy Nandy
Lucy Nandy
JRJonathan Reid
Jonathan Reid
Hygroscopicity data for 36 organic compounds, including amino acids, organic acids, alcohols and sugars, are determined using a comparative kinetics electrodynamic balance (CK-EDB). The CK-EDB applies an electric field to trap-charged aqueous droplets in a chamber with controlled temperature and relative humidity (RH). The dual micro dispenser set-up allows for sequential trapping of probe and sample droplets for accurate determination of droplet water activities from 0.45 to > 0.99. Here, we validate and benchmark the CK-EDB for the homologous series of straight-chain dicarboxylic acids (oxalic–pimelic) with measurements in better agreement with Universal Quasichemical Functional Group Activity Coefficients (UNIFAC) predictions than the original data used to parametrise UNIFAC. Furthermore, a series of increasingly complex organic compounds, with subtle changes to molecular structure and branching, are used to rigorously assess the accuracy of predictions by UNIFAC, which does not explicitly account for molecular structure. We show that the changes in hygroscopicity that result from increased branching and chain length are poorly represented by UNIFAC, with UNIFAC under-predicting hygroscopicity. Similarly, amino acid hygroscopicity is under-predicted by UNIFAC predictions, a consequence of the original data used in the parametrisation of the molecular subgroups. New hygroscopicity data are also reported for a selection of alcohols and sugars and they show variable levels of agreement with predictions.

16 August 2016 in The Journal of Physical Chemistry A
Verified
Journal Article
Open access
CCChen Cai
Chen Cai
RMRachael E. H. Miles
Rachael E. H. Miles
MCMichael I. Cotterell
Michael I. Cotterell
AMAleksandra Marsh
Aleksandra Marsh
GRGrazia Rovelli
Grazia Rovelli
JRJonathan P. Reid
Jonathan P. Reid
Representing the physicochemical properties of aerosol particles of complex composition is of crucial importance for understanding and predicting aerosol thermodynamic, kinetic, and optical properties and processes and for interpreting and comparing analysis methods. Here, we consider the representations of the density and refractive index of aqueous–organic aerosol with a particular focus on the dependence of these properties on relative humidity and water content, including an examination of the properties of solution aerosol droplets existing at supersaturated solute concentrations. Using bulk phase measurements of density and refractive index for typical organic aerosol components, we provide robust approaches for the estimation of these properties for aerosol at any intermediate composition between pure water and pure solute. Approximately 70 compounds are considered, including mono-, di- and tricarboxylic acids, alcohols, diols, nitriles, sulfoxides, amides, ethers, sugars, amino acids, aminium sulfates, and polyols. We conclude that the molar refraction mixing rule should be used to predict the refractive index of the solution using a density treatment that assumes ideal mixing or, preferably, a polynomial dependence on the square root of the mass fraction of solute, depending on the solubility limit of the organic component. Although the uncertainties in the density and refractive index predictions depend on the range of subsaturated compositional data available for each compound, typical errors for estimating the solution density and refractive index are less than ±0.1% and ±0.05%, respectively. Owing to the direct connection between molar refraction and the molecular polarizability, along with the availability of group contribution models for predicting molecular polarizability for organic species, our rigorous testing of the molar refraction mixing rule provides a route to predicting refractive indices for aqueous solutions containing organic molecules of arbitrary structure.

24 May 2018 in Physical Chemistry Chemical Physics
Verified
Journal Article
Open access
PDF file
AMAleksandra Marsh
Aleksandra Marsh
SPSarah Suda Petters
Sarah Suda Petters
NRNicholas Ernest Rothfuss
Nicholas Ernest Rothfuss
GRGrazia Rovelli
Grazia Rovelli
YSYoung Chul Song
Young Chul Song
MPMarkus Dirk Petters
Markus Dirk Petters
A Dimer Coagulation, Isolation and Coalescence (DCIC) technique is used to probe the phase behaviour and glass transition temperatures of ternary aerosol mixtures. The DCIC technique is used to perform temperature and relative humidity dependent viscosity measurements at viscosities near 5 × 106 Pa s. Measurements include organic–organic and organic–inorganic mixtures composed of sucrose–citric acid and sucrose–sodium nitrate. The data reported here add additional insight into the wide discrepancies in glass transition temperatures reported for pure sodium nitrate. The phase diagram model used in the work of Rothfuss and Petters (Phys. Chem. Chem. Phys., 2017, 19, 6532–6545) is expanded to include multiple solute components. Data and model predictions of the mixtures are in good agreement with the modified model. These measurements are compared with values from Holographic Optical Tweezer (HOT) measurements taken at room temperature. Overall, the viscosities determined from the DCIC and HOT techniques are in good agreement.

27 January 2017 in Faraday Discussions
Verified
Journal Article
Closed access
PDF file
AMAleksandra Marsh
Aleksandra Marsh
GRGrazia Rovelli
Grazia Rovelli
YSYoung-Chul Song
Young-Chul Song
KPKelly L. Pereira
Kelly L. Pereira
RWRose E. Willoughby
Rose E. Willoughby
JRJonathan Reid
Jonathan Reid
Laboratory studies can provide important insights into the processes that occur at the scale of individual particles in ambient aerosol. We examine the accuracies of measurements of core physicochemical properties of aerosols that can be made in single particle studies and explore the impact of these properties on the microscopic processes that occur in ambient aerosol. Presenting new measurements, we examine here the refinements in our understanding of aerosol hygroscopicity, surface tension, viscosity and optical properties that can be gained from detailed laboratory measurements for complex mixtures through to surrogates for secondary organic atmospheric aerosols.

14 August 2017 in Environmental Science & Technology
Verified
Journal Article
Open access
CCChen Cai
Chen Cai
AMAleksandra Marsh
Aleksandra Marsh
YZYun-Hong Zhang
Yun-Hong Zhang
JRJonathan Reid
Jonathan Reid
We introduce and assess a group contribution scheme by which the refractive index (RI) (λ = 589 nm) of nonabsorbing components common to secondary organic aerosols can be predicted from the molecular formula and chemical functionality. The group contribution method is based on representative values of ratios of the molecular polarizability and molar volume of different functional groups derived from data for a training set of 234 compounds. The training set consists of 106 nonaromatic compounds common to atmospheric aerosols, 64 aromatic compounds, and 64 compounds containing halogens; a separate group contribution model is provided for each of these three classes of compound. The resulting predictive model reproduces the RIs of compounds in the training set with mean errors of ±0.58, ±0.36, and ±0.30% for the nonaromatic, aromatic, and halogen-containing compounds, respectively. We then evaluate predictions from the group contribution model for compounds with no previously reported RI, comparing values with predictions from previous treatments and with measurements from single aerosol particle experiments. We illustrate how such comparisons can be used to further refine the predictive model. We suggest that the accuracy of this model is already sufficient to better constrain the optical properties of organic aerosol of known composition.