The influence of the preparation methods on the physicochemical properties of Cu and Al oxides was studied. Four different preparation methods were used to synthesize the oxides (catalysts): co-precipitation by the hydrotalcite precursor route (CuAl-HT-c), the solid-state reaction route (CuAl-s), the physical mixing of the oxides (CuAl-o), and individual oxide precipitation followed by physical mixing (CuAl-p). Chemical analysis, X-ray diffraction and textural analysis results of the precursor CuAl-HT-c showed that the respective preparation method is efficient to obtain the hydrotalcite phase with high purity as well as generating a mixed oxide with the greatest surface area among all of the catalysts in this study. The efficacy of this method should be highlighted as it is very difficult to obtain high purity hydrotalcites with copper and aluminum. Furthermore, through the evolution of the FWHM with temperature, this method provided a structurally and texturally more stable mixed oxide. The thermal reducibility of the CuAl-HT-c catalyst was also much higher than that observed in the Cu and Al oxides prepared by other methods. Under an He flow, the CuAl-HT-c catalyst showed a significant reduction of CuO starting at 440 °C, with the formation of Cu2O and metallic Cu, confirmed by XRD and XANES, both in situ. When investigating the effect of the pretreatment gas for this catalyst, H2 reduction occurs faster than with CO, and with less Cu+ formation. Thus, Cu and Al mixed oxides obtained from a precursor with the hydrotalcite structure showed advantages over other methods, presenting unique textural and reducibility properties.
5 December 2022 in Journal of Thermal Analysis and Calorimetry
This study investigated the kinetics of the reduction reaction of nitric oxide (NO) by carbon monoxide (CO), aiming to evaluate NOx emissions in automotive exhaust gases. Although the overall reaction leads to the formation of inert nitrogen gas (N₂), nitrous oxide (N₂O), a potent greenhouse gas, can arise as a byproduct, depending on the catalyst composition and operating conditions. The study demonstrates that light-off curves are an effective and practical method for determining the kinetic parameters and product distribution in the reduction of NO by CO over Pd/Al₂O₃. These curves provide results consistent with isothermal experiments, while requiring simpler and faster procedures. N₂O was identified as a reaction intermediate, formed in the partial conversion of NO and consumed as N₂ becomes the dominant product. Its formation occurs over a wide temperature range, which is especially relevant for cold start conditions in gasoline engines. The Pd/Al₂O₃ catalyst demonstrated high thermal stability and resistance to deactivation up to 500 °C. A first-order kinetic model successfully reproduced the main experimental trends, including the transient behavior of N₂O. Graphical Abstract The alternative text for this image may have been generated using AI.