23 July 2015 in IEEE Transactions on Microwave Theory and Techniques
Modified coupled feed-lines (MCFLs) and coupled-line stubs (CLSs)/coupled-line stub-loaded resonators are proposed and applied to design wideband balanced filters to obtain high selectivity and common-mode suppression. MCFLs are implemented by loading short- and open-circuited stubs at the end of the traditional parallel-coupled feed-lines to perform bandpass and bandstop response, respectively. Impedance matching and additional transmission poles guarantee that the filters have wideband differential-mode (DM) passband. Transmission zeros can be allocated to suppress the common mode through different electrical length of stubs. Moreover, the CLSs and its stub-loaded resonators have the property of dual transmission zeros outside the passband, which improves the selectivity of the DM passband. Specifically, two prototypes based on CLSs with second harmonic suppression and CLS-loaded resonators with sharp rejection (Δf3dB / Δf20dB=0.97) are designed and fabricated for demonstration. The simulation and measurement results are in good agreement.
23 October 2013 in IEEE Microwave and Wireless Components Letters
A circuit for differential wideband bandpass filter (BPF) is presented. The circuit works as a bandpass and bandstop filter under differential- and common-mode excitation, respectively. Under differential-mode, two transmission zeros are generated by the short-ended parallel-coupled stubs and supply a very sharp differential passband. The circuit parameters are analyzed and given to show the circuit characteristics. Finally, the circuit is implemented using microstrip technology and a differential wideband BPF is designed, simulated and measured. Simulated and measured results are well agreed.
4 January 2021 in IEEE Microwave and Wireless Components Letters
This letter proposes a new design method of dual-band filtering differential phase shifter using cascaded wideband phase shifter and bandstop network. After cascading the bandstop network, the phase shift characteristic of the initial wideband filtering differential phase shifter remains unchanged, while its wide passband is divided into dual subpassbands. Compared with traditional dual-band-filter-based topology, the proposed cascaded one features the advantage of independently controlled phase and amplitude responses, and can achieve the same phase shifts in two passbands that conventional one cannot. For verification, a dual-band differential phase shifter with two same phase shifts of 90° is designed, fabricated, and measured. Simulated and measured results show good agreement.
9 January 2020 in IEEE Transactions on Antennas and Propagation
This communication proposes a wideband low-profile circularly polarized patch antenna based on a broadband 90° modified Schiffman phase shifter and a meandering L-shaped microstrip feed. The whole antenna consists of a broadband hybrid feeding network and a circular patch radiator. The hybrid network has two branches that operate in the first and second Schiffman periods, and thus can achieve 113% 10-dB return loss bandwidth and 75% phase shift bandwidth within 90 ± 4.6° under a relaxed coupling strength of 1.58. To reduce the profile, the planar microstrip L-shaped feeding probe is properly meandered, which provides not only broadband impedance matching, but also an extra degree of freedom in reduction of the cross polarization, thus achieving a wide axial ratio bandwidth. Simulated and measured results show that the antenna has indeed achieved a low profile (0.05λ0) with 50.5% impedance bandwidth, 47.8% axial ratio bandwidth, and 34% gain bandwidth (>3 dBi).
26 September 2017 in IEEE Microwave and Wireless Components Letters
Novel multiband balanced bandpass filters with controllable bandwidths are presented in this letter. Slotline coupled-feed structure (SLCFS) is employed to suppress the common mode (CM), due to its intrinsic CM rejection. For differential mode, the tri-band/quad-band performance is realized by three/four pairsofhalf-wavelength resonators, which are designed for different passbands, respectively. Since the load effects between different resonators are very slight, the passband frequencies and bandwidths can be independently tuned and designed. Moreover, quasi-elliptical bandpass responses could be achieved to enhance the selectivity. Finally, two multiband balanced filters are designed and fabricated to validate the design method. To the best of authors' knowledge, the quad-band balanced filter may be the first ever reported.
28 April 2023 in IEEE Transactions on Antennas and Propagation
In this communication, a wideband rectifying metasurface for RF energy harvesting is proposed. By virtue of the two resonant modes of the paralleling metasurface resonator, it is not only the wideband feature can be obtained but also enables direct impedance matching between the high impedance diode and high impedance metasurface, eliminating impedance matching. A DC feed structure is proposed where each unit of the metasurface is connected by the chip inductors, and DC energy can be combined and exported directly, eliminating power combining networks. Then, A 6 × 6 array was designed and fabricated. Experimental results show that the proposed rectifying metasurface system operates at 5.32–6.66 GHz with a fractional bandwidth of 22.4%, and the peak efficiency is 74.5%. As a contribution to this work, RF energy on a broader frequency range can be captured by the proposed system with higher system efficiency, while maintaining a simple structure. This shows its great potential in wireless power transfer and indoor RF energy harvesting.