22 November 2017 in ECS Journal of Solid State Science and Technology
III-Nitrides are attracting considerable attention as promising materials for a wide variety of applications due to their wide coverage of direct bandgap range, high electron mobility, high thermal stability and many other exceptional properties. The light-emitting diodes based on III-Nitrides revolutionize the solid-state lighting industry. III-Nitrides based solar cells and thermoelectric generators support the sustainable energy progress, and the III-Nitrides are better alternatives for power and radio frequency (RF) electronics compared with silicon. The doped III-Nitrides’ magnetic properties and sensitivity to radiation can contribute to novel spintronic and nuclear detection devices. This paper will review III-nitride material properties and their corresponding applications in LEDs, solar cells, power and radio frequency (RF) electronics, magnetic devices, thermoelectrics and nuclear detection. The typical values of electrical, optical, thermoelectric, magnetic properties are cited, the current state of art investigations are reported, and the future applications are estimated.
1 May 2016 in Neurocomputing
24 June 2020 in Journal of Vacuum Science & Technology A
This paper investigates manganese-doped zinc oxide (ZnMnO) thin films grown using the atomic layer deposition (ALD) technique. ZnO and MnO layers were deposited alternatively using diethyl zinc and manganese (III) acetylacetonate (Mn(acac)3) as metallic precursors. A suppressed growth rate for both materials was observed during the growth of ZnMnO samples, which is due to reduced adsorption of the precursor molecules on the surface of the sample. Structural characterization of the ZnMnO films shows a weak polycrystalline structure for the as-deposited thin films. On the other hand, thermally annealed samples demonstrated a textured polycrystalline structure with a distinct (002) orientation. A red shift in the near band edge absorption was observed by increasing the Mn:Zn ratio. The results of this work demonstrate the potential in ALD growth of high-quality wide bandgap ZnMnO thin films that can be used as an active semiconductor material in memory and logic devices.
26 January 2023 in Journal of Lightwave Technology
In this paper, a record-high single-mode output power from a multi-junction vertical-cavity surface emitting laser (VCSEL) emitting at 905nm is achieved. Single spectral mode emission of the VCSEL is realized by using an anti-phase mode filter, placed at the top surface of the device, that acts as a relief layer to suppress the higher order transverse modes. Placement of such anti-phase layer at the surface areas in which the higher order modes are expected to emit, leads to reduction in the effective mirror reflectivity at those areas, increased optical losses, and consequently, increased threshold gain for the higher order modes compared to the fundamental mode. The room-temperature light-current-voltage characteristics of a 6-junction 905nm VCSEL with an oxide aperture size of ∼8μm and mode filter size of 5μm shows a single-mode optical power of 12.55mW and maximum power conversion efficiency of 56.48%. Moreover, the emission spectrum of this device shows a stable side-mode suppression ration of >30dB in the single-mode operation regime. The VCSEL remains reliably single-mode at higher temperatures, generating a maximum optical output power of 9.48mW at 60°C. Such remarkable single-mode performance can be mainly attributed to the multi-junction epitaxial structure of the device, in which the output optical power is expected to proportionally increase according to the number of bipolar cascade active regions.
31 December 2019 in Journal of Vacuum Science & Technology A
In this paper, a novel field-effect passivation technique is used to improve the photovoltaic properties of metal/n-GaAs Schottky junction solar cells. In this technique, a relatively large density of positive or negative fixed charges existing at the top surface of the dielectric thin films is used to create an electric field gradient to prevent the photogenerated charge carriers from recombining. Atomic layer deposition is used to grow high-quality Al2O3 and ZnO ultrathin films that are used as passivating materials. Electrical measurements demonstrate an improvement in both diodelike and photovoltaic properties of Schottky solar cells in the proposed stacked Al2O3/ZnO passivation structure compared to the single Al2O3 layer. This can be attributed to both higher equivalent capacitance/permittivity of the stacked passivation layer and increased density of negative fixed charges at the interface of the passivation layer and the semiconductor.