This paper presents the effect of eccentricity and surface roughness on the probabilistic performance of two axial groove hydrodynamic journal bearing. In general, it is difficult to quantify experimentally the variabilities involved in dynamic responses of the hydrodynamic bearing due to the randomness involved in surface asperity and eccentricity ratio. The deterministic models available for the analysis of the bearings are not capable to include such uncertainties. Thus, the focus of the study is to quantify such uncertainties on the performance of a two axial grooved journal bearing. To simulate the variabilities of the stochastic variables, Monte Carlo simulation (MCS) is carried out. The steady-state and dynamic coefficients are obtained by solving the Reynolds equation using a surrogate-based finite difference method. The moving least square (MLS) method is used as the surrogate model to increase the computational efficiency of MCS.
1 February 2020 in Journal of Physics: Conference Series
The primary factor that defines the final performance of any composite material is the fiber-matrix interface. Hence, efficient amount of adhesion is needed for full-fledged performance of composite materials. When fibers are used without surface modification, they tend to produce composites with low strength. This in turn leads to weak adhesion and poor bonding between the fiber and matrix. Hence, there is a massive apprehension to alter the surface of fibers through various procedures, in order to overcome their intrinsic downsides and effectively employ these materials in countless applications. This paper deals with a review of prevailing research studies fixated on the surface treatment of fibers.
Resistive-inductive shunt circuits, also called resonant shunt circuits, are commonly used in conjunction with piezoelectric materials to promote passive vibration control. These circuits work similarly to a band-pass filter, tuning a certain frequency range and dissipating the piezoelectric energy relevant to the tuning. However, there is a problem when there is a need for low-frequency tuning. This problem is caused by the inductive element of the circuit, as there is an inversely proportional relationship between the inductive value and frequency tuning. In other words, to choose to tune a low frequency we will have to use a high-value inductor, which denotes the generation of an electromagnetic field due to the coil which in this aspect is also volumetrically unfeasible for storage in small areas. That said, the present study aims to analyze and compare the use of three synthetic inductance circuits for low-frequency tuning, they are: the Antoniou circuit; the Riodan circuit; and the Gyrator circuit. These inductances were compared in four cases where different resistive values selected the same tuning zone. The results demonstrate that both synthetic inductances showed similar dissipation effects, but in the Gyrator inductance, there was slightly less dissipation for both cases analyzed.