5 January 2021 in ACS Catalysis
6 January 2020 in Nanoscale
Atomic Layer Deposition of MoS2 with controlled crystallinity on nanoporous graphene foams are highly promising hierarchical materials for numerous applications. A trade-off between the defect density and crystallinity for improved HER performance is reported.
2 March 2021 in ACS Applied Energy Materials
Decreasing the cost and improving the durability of polymer electrolyte membrane fuel cell (PEMFC) electrodes are two major unresolved challenges. Electrodeposition of low-dimensional Pt on transition metal carbide supports could be a way to simultaneously address both issues. Synthesis of low-dimensional Pt typically requires expensive equipment or techniques that are difficult to reproduce or scale. An electrodeposition-based technique to accomplish this goal is therefore highly desirable. The strong adhesion energy between Pt and the C sites on the α-Mo2C surface suggests that an electrochemical technique could be exploited for this purpose. Here, PtCl62– was electrodeposited onto an α-Mo2C support at low and high overpotentials (η). A dramatic increase in the electrochemical surface area and the mass activity of the oxygen reduction reaction (ORR) was observed when Pt was deposited at low overpotentials (+8 and +18 mV vs SCE) as compared to high overpotentials (−67 and −92 mV vs SCE). Indeed, catalysts prepared in the low-overpotential region achieved an ORR mass activity of 275 A/gPt and broke the linear relationship between mass activity and loading typically exhibited by these materials. Furthermore, catalysts prepared in the low-overpotential region exhibited superior stability out to 5000 cycles in an accelerated stress test (AST) as compared to samples prepared at higher overpotentials or by chemical reduction of Pt onto α-Mo2C and carbon supports.
6 December 2019 in Journal of the Electrochemical Society
Cathode catalysts in polymer electrolyte membrane fuel cells (PEMFCs) are often supported by carbon, which is susceptible to corrosion at operating potentials. Transition metal carbides (TMCs) are a class of material that could be used as catalyst supports to replace carbon as they are electrically conductive and can be resistant to corrosion. TMCs which show promising activity for the oxygen reduction reaction (ORR) have been shown to suffer from oxidation and dissolution, whereas corrosion-resistant carbides tend to have significantly lower ORR activities. Here we used co-reduction carburization to synthesized alloys of Mo2C and TaC with the aim of designing a carbide support that was both active and corrosion resistant. The addition of 15 mol% Ta to the precursor mixture used to synthesize the alloy support increased the corrosion potential by nearly 150 mV and decreased the corrosion current to 16% of that observed in the Ta-free support. While Ta-alloyed Mo2C supports had reduced ORR activity compared to their Ta-free counterparts, the Ta-alloyed supports performed favorably when compared to Vulcan XC-72. We show that further improvements to alloy-carbide based supports can be achieved by modulating the structure of the catalyst particles from Pt to Pt3Ni. Furthermore, density functional theory (DFT) calculations can be used to predict oxygen binding and corrosion resistance in digitally designed alloy carbides.