1 November 2021 in Journal of Ecological Engineering
The continuous system of lead adsorption on rice husks was investigated in this paper. A fixed bed study was performed in many tests to investigate the influence of pH, the adsorbent height, the initial concentration of lead, the flow rate and processing time on the lead adsorption process. The results demonstrated that the lead removal capacity decreased when the pH value of the solution and the flow rate increased. The lead removal capacity increased due to the decreased initial concentration of lead. The results showed that the removal capacity increases along with the processing time and the adsorbent height in column. The largest removal was (81%) at pH of 4, the adsorbent height (50 cm), the initial concentration of lead (10 mg/l), the processing time (90 min.) and the flow rate (10 ml/min.). As a result, rice husks can be used to remove the lead instead of expensive commercial adsorbents, due to its availability, inexpensive and perfect adsorption property.
1 October 2021 in Journal of Ecological Engineering
In this paper, an electro-kinetic technique was applied to remove chromium from contaminated soil. This technique is appropriate for the soils with low permeability. Various experiments were carried out under different operating conditions, including various purging solutions. Garlic peels powder (GPP) was used in this study as a cheap adsorbent substance to avert the flow of reverse osmosis, which may affect the removal percentage. The results proved that the removal percentage increased as the pH of the purging solutions decreased. The first three experiments were performed with purging solution at pH of 4, 6, and 8 respectively. The highest removal percentage was 66.3% at pH of 4 compared to the other two experiments at pH of 6 and 8, where the removal percentages were 53.3% and 49.7%, respectively. This paper showed that the percentage of chromium removal decreased along with the voltage. The removal percentage at 1.5 V/cm was 66.3%, while at 1 V/cm was 61%. Garlic peels powder (GPP) is considered as an effective adsorbent material to avert the reverse osmosis flow. Therefore, the use of this material in this study will give a new impression on the application of these products as an absorbent medium.
1 November 2021 in Journal of Ecological Engineering
Wastewater management is considered to be a great challenge particularly in towns and cities with rapidly grown population. The study aimed to assess Al-Muamirah WW treatment plant (WWTP), located in Babylon governorate of Iraq, in terms of its hydraulic loading as a quality performance...
10 March 2016 in Environment and Natural Resources Research
SIShatha Abduljabbar Ibrahim
Shatha Abduljabbar Ibrahim
Different Advanced Oxidation Processes (Photo Fenton process, Fenton process and H2O2/UV) were studied in order to reduce COD from oily compounds aqueous solution using batch system. To get the optimum condition, different variables were studied for each of these processes; such as pH, time, concentration of H2O2, concentration of oil, concentration of FeSO4·7H2O and temperature as parameters. It was found that the optimal pH value for the three processes was 3 and the optimal temperature was 30oC for Photo-Fenton and UV/H2O2 system and 20oC for Fenton process. Photo-Fenton process gave a maximum COD reduction of 80.59 % (COD from 2684 to 521 mg/l), Fenton gave 53.22 % (COD from 2587-1130) and the combination of UV/H2O2 gave a COD reduction of 22.69 % (COD from 2450 to 1894). The percentage of removal found was after the total reaction time (180 min.). The optimum chemical reagents for Photo-Fenton, Fenton and UV/H2O2 were as the following H2O2 = 800 mg/l, 1500 mg/l and 2000 mg/l, Fe2SO4·7H2O = 60 mg/l, 100 mg/l.
10 January 2025 in Journal of Ecological Engineering
The research aims to prepare and study environmentally friendly materials from mixture shells of almond, pistachio, peanut, and walnut (APPWS) as adsorbents for the removal of phenols from wastewater, then synthesis activated biochar through chemical activation using phosphoric acid, The results...
6 May 2021 in Journal of Petroleum Research and Studies
This research work is to study the performance of evaporative cooling system using new type of packing with different shapes (saddle, counter current wavy, and triangular splash) and materials (glass, thermoplastic, and resistance wood) of packing for an air –water cooling system . The basis of the installation is the evaporative cooling system,1.75 m height and 40 x 40 cm outside cross section. The fluids in this system are air which moving from the bottom to the top of cooling system (mass flow rates ranging between 0.07 and 0.18 kg/s) and the water which are moving from top to bottom of cooling evaporator ((mass flow rates ranging between 0.11 and 0.27kg/s)). The inlet water temperatures ranging between 35 and 55oC .The packing heights were changed during the research in order to get the temperature profile and the relation of these temperatures with the other variables in the cooling system, the packing heights ranging between 35 to 140 cm. The overall volumetric heat and mass transfer coefficients and tower characteristics, were predicted as a function of the fluids flow rates. A computer program used to solve and find the relation between the variables in the system and the functions (overall volumetric heat and mass transfer coefficients, number of transfer coefficient, the temperature variation along the tower). The results show that : 1-At maximum air mass flow and minimum water mass flow, the mass transfer coefficients would be on the maximum value and vice-versa. 2- The thermoplastic packing was much more efficient than glass and wood by efficiency about 12 to 18 %. ,also the results showed that The triangular packing was much more efficient than wavy and glass by efficiency about 5 to 11 %. 3-The temperatures distribution were not constant in all layers; the temperatures distribution in the first layer were not very well, this happened because the distribution of water in the packing surface was just know happened, while in the other layers the temperature distrib-ution and profile were so good.