It is the purpose of this paper to analyse the possibility of reducing the vibrations of frame building structures with the help of multiple tuned mass dampers. Structures exposed to strong winds are considered. Excitation forces, which are functions of wind velocity fluctuations, are treated as random forces. The spectral density functions of wind velocity fluctuations are assumed as proposed by Davenport. The correlation theory of random vibration is used and the root mean squares of displacements and accelerations are determined. Several remarks, concerning the effectiveness of multiple tuned or mass dampers, are formulated from the results of calculation. Santrauka Nagrinėjama galimybė sumažinti stipraus vėjo veikiamų rėminių pastatų konstrukcijų svyravimus, taikant masės slopintuvų sistemą. Vibracijas sukeliančios jėgos, priklausančios nuo vėjo greičio svyravimų, laikomos atsitiktiniais dydžiais. Vėjo greičio svyravimo spektro tankio funkcijos nagrinėjamos Davenport metodu. Atlikus atsitiktinių vibracijų regresinę analizę, nustatytos poslinkių ir pagreičių vidutinės kvadratinės paklaidos. Remiantis skaičiavimo rezultatais, padarytos masės slopintuvų efektyvumo išvados.
The paper presents a comparison of three strain measurement methods. The mechanical parameters of S355 grade steel (yield strength, tensile strength, modulus of elasticity) were determined in tensile tests. Strains were measured using high resolution measuring instruments: an extensometer, a strain gauge and an ARAMIS 3D DIC system. In this paper, these three instruments have been used simultaneously in tensile tests for the first time. The results indicate that the values of the Young’s modulus obtained using different techniques were similar when each instrument measured strain on the same side of the sample. Small differences were connected with different gauge lengths and their locations. The values of the Young’s modulus determined on the opposite sides of the samples were more varied even when the same method was used (strain gauge measurements). For this reason, it is recommended to use double-sided averaging instruments when the Young’s modulus is determined. The strain-curves obtained from the strain gauge measurements were incomplete and they came to an end at the end of the yield plateau due to the fact that they were damaged when the values of strain were relatively high. The extensometer was used up to the point where the strain reached 0.3% and then the strain was measured based on the distance between the machine clamps. The stress-strain curves obtained from the DIC system were complete because the system was able to monitor the sample until the very end of the tests.