1 November 2016 in Measurement
20 January 2019 in Periódico Tchê Química
The hardness test is one of the most important mechanical tests used by the metal-mechanical industry. The quality assurance of the measured results is mainly due to the human factor, which is involved in the verification, adjustment, and operation of the measuring equipment. Therefore, the main goal of this paper is to design and develop verification standards for Brinell (HB) and Rockwell (HRC) scales from low alloy carbon steels subjected to different types of heat treatment. In order to assure the reliability of the hardness values of the verification standards, they have been measured on equipment calibrated by laboratories belonging to the Brazilian Calibration Network (RBC). The results showed similar values based on ten measurements made on the standards surface.
1 July 2016 in Journal of Physics: Conference Series
The plastic strain ratio is an important parameter for the evaluation of the anisotropy of sheet metals in deep-drawing processes. This paper presents the results of an intralaboratory comparison for the anisotropy test, using normalized error as statistic method of analysis. The study was carried out through the comparison of the results obtained from different operators for the same sheet metal. The results of the study are considered satisfactory.
1 April 2018 in REM - International Engineering Journal
The reliable determination of materials' mechanical properties is a fundamental factor for their application in engineering, and the estimation of the measurement uncertainty in testing laboratories has a direct impact on the interpretation of the results. Recent literature demonstrates that one of the most widely used methodologies for uncertainty estimation, the Guide to the Expression of Uncertainty in Measurement (GUM), has limitations, especially in cases where the mathematical model has a high degree of non-linearity. Furthermore, it makes approximations for the final probability distribution. In these cases, it is recommended that the measurement uncertainty is determined by the Monte Carlo Method (MCM), which considers the propagation of the distribution rather than the propagation of uncertainties. Thus, given the limitations of the GUM method and the importance of estimating the measurement uncertainty of mechanical tests, this work aims to implement the measurement uncertainty estimation for the plane-strain fracture toughness (KIC) test of metallic materials through the Monte Carlo Method. The results of the work confirm the importance of estimating the measurement uncertainty of fracture toughness tests.