4 June 2019 in Advanced Materials
29 May 2020 in Soft Matter
Magnetically-switchable adhesion of a two-phase composite to non-magnetic objects is achieved by magnetically addressing the material dissipative properties.
10 January 2017 in Science and Technology of Advanced Materials
Tinted and colour-neutral semitransparent organic photovoltaic elements are of interest for building-integrated applications in windows, on glass roofs or on facades. We demonstrate a semitransparent organic photovoltaic cell with a dry-laminated top electrode that achieves a uniform average visible transmittance of 51% and a power conversion efficiency of 3%. The photo-active material is based on a majority blend composed of a visibly absorbing donor polymer and a fullerene acceptor, to which a selective near-infrared absorbing cyanine dye is added as a minority component. Our results show that organic ternary blends are attractive for the fabrication of semitransparent solar cells in general, because a guest component with a complementary absorption can compensate for the inevitably reduced current generation capability of a high-performing binary blend when applied as a thin, semitransparent film.
1 January 2022 in SSRN Electronic Journal
Directly 3D printed metal microstructures could enable hybrid micromanufacturing, combining conventional micromanufacturing with additive micromanufacturing (µAM). The microstructure’s material properties, including the electrical resistivity, are of decisive importance for a wide range of applications in microelectronics, high-frequency communication, and bioengineering. In this work, we present a room-temperature process for µAM of gold structures based on local electrodeposition. We demonstrate control of the electrodeposition process by regulating the precursor species supply rate through air pressure and by regulating the reaction rate through the electrodeposition potential. We 3D printed complex gold microscale structures and characterized the resistivity of the printed gold by four-point probe measurements. Additionally, we printed copper microwires using a previously demonstrated copper µAM process and measured the copper resistivity. We found remarkably low resistivity values of 65 nΩ . m and 19 nΩ . m for the gold and copper wires, respectively, without post-treatment. Microstructural analysis of the gold wires revealed a dense metal deposit free of voids. Finally, we printed gold structures on a pre-patterned substrate, paving the way to hybrid devices in which additive micromanufacturing is combined with existing micromanufacturing techniques.