29 September 2022 in Journal of Hospital Infection
Carbapenem-resistant hypervirulent Klebsiella pneumoniae (CR-hvKP) poses serious challenges to public health. Only a few sporadic reports of strains co-producing NDM-1 and KPC-2 (NDM-1-KPC-2-CR-hvKP strains) are available to date. This retrospective study investigated the clinical features, prevalence and antibiotic resistance of hvKP in a tertiary hospital in central China, and characterized an NDM-1-KPC-2-CR-hvKP strain (KP169). Clinical data were collected. Antimicrobial and virulence-associated phenotyping and genotyping, capsular serotype gene analysis and multi-locus sequence typing of hvKP isolates were performed. Whole-genome sequencing (WGS) was performed on strain KP169. Forty-five of 109 K. pneumoniae clinical isolates were hvKP. Of these, 37 originated from nosocomial infections and 24 expressed carbapenemases. Eight NDM-1-KPC-2-CR-hvKP strains were identified, and enterobacterial repetitive intergenic consensus polymerase chain reaction showed that they were clonally related. WGS revealed that strain KP169, which belongs to ST11-K64, had a single 5.5-Mb chromosome and six plasmids of 5.5-221.6 kb. The blaNDM-1 gene was located on plasmid pKP169-P3, and blaKPC-2, blaSHV-12 and blaTEM-1 were located on IncFII/IncR pKP169-P2. IncHI 1/IncFIB virulence plasmid pKP169-P1 was similar to pKPC-CR-hvKP-C789 plasmid reported previously. Plasmid stability testing showed that blaKPC-2- and blaNDM-1-harbouring plasmids were maintained stably in the host. To the best of the authors' knowledge, this study identified the largest cohort, to date, of eight NDM-1-KPC-2-CR-hvKP strains, and suggests that antimicrobial stewardship and protocols to prevent transmission are needed urgently.
4 May 2021 in IET Conference Proceedings
This paper creatively select rack section tooth profile of the basic hob as basic rack of harmonic drive. On the basis of the main parameter selection method of the datum tooth profile, this paper presents the optimum design method of the basic rack and the design flow. In this paper, an example is given to verify the correctness and feasibility of the design method of standard tooth profile. It is concluded that the tooth top and tooth root profile of Circular Spline are formed by the tooth top profile of Flexspline, and the tooth profile of the middle segment of Circular Spline is formed by the tooth profile of the middle involutes segment of Flexspline. The results show that the tooth profile can truly realize the full tooth conjugate contact, and can greatly improve the comprehensive performance of harmonic gear drive.