Xuejian Chen

Xuejian Chen

Auto-generated profile, based on publicly available information

Xuejian Chen

Key Laboratory of Road and Traffic Engineering of the State Ministry of Education, Tongji University, Shanghai, China

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 February 2022 in IEEE Transactions on Intelligent Transportation Systems
Verified
Journal Article
Closed access
XCXuejian Chen
Xuejian Chen
JYJuyuan Yin
Juyuan Yin
Keshuang TangKeshuang Tang
Keshuang Tang
YTYe Tian
Ye Tian
JSJian Sun
Jian Sun
Vehicle trajectories can provide a clear picture of traffic flow, which facilitates traffic state estimation and signal control optimization at intersections. Connected and Automated Vehicles (CAVs) can not only report their own trajectories, but also continuously collect surrounding vehicles’ trajectories using onboard sensors, which creates an opportunity to reconstruct fully-sampled vehicle trajectories. However, this data source brings challenges such as low penetration rate of CAVs and complex detection environment at intersections. To address these problems, this study proposes a novel framework under micro-perspective, in which trajectory estimation and fusion algorithms are integrated. The spatiotemporal correlations of detected trajectories are analyzed and classified into four regions, and four corresponding trajectory estimation algorithms based on extended car-following model are established to estimate the undetected part of each trajectory. Furthermore, a trajectory fusion algorithm based on Particle Filter is developed to fuse the estimated trajectories separately derived from upstream and downstream with minimized errors. The proposed method was comprehensively evaluated at field and simulated signalized intersections. The results show that compared with Variational Theory method, queue location error, time error and cumulative distance error of the proposed method were 76.3%, 44.4% and 54.5% lower, respectively, and the proposed trajectory fusion algorithm improved the accuracy and smoothness with the above three indices decreased by 17.3%, 47.7% and 6.2%, respectively. It was also found that the proposed method can adapt to different traffic conditions and penetration rates of CAVs.

6 May 2025 in Transportation Research Part C: Emerging Technologies
Verified
Journal Article
Closed access
XCXuejian Chen
Xuejian Chen
GQGuoyang Qin
Guoyang Qin
JSJian Sun
Jian Sun

1 November 2025 in IEEE Transactions on Intelligent Transportation Systems
Verified
Journal Article
Closed access
XSXinghao Su
Xinghao Su
XCXuejian Chen
Xuejian Chen
GQGuoyang Qin
Guoyang Qin
JYJuyuan Yin
Juyuan Yin
JSJian Sun
Jian Sun


5 June 2026 in SSRN Electronic Journal
Verified
Preprint
Open access
JYJuyuan Yin
Juyuan Yin
YCYuqian Chen
Yuqian Chen
BLBing Li
Bing Li
XCXuejian Chen
Xuejian Chen
JMJingfeng Ma
Jingfeng Ma
Millimeter-wave radar and video integrated detectors have been widely used in intelligent transportation systems for vehicle trajectory data collection. However, to balance coverage and cost, these detectors are often deployed sparsely, resulting in a considerable amount of missing trajectory data. This approach poses considerable challenges for detection, making continuous vehicle tracking in complex traffic scenarios extremely difficult. To overcome this challenge, we employ deep generative learning to reconstruct vehicle trajectories. Specifically, we propose CITR-GAN, a collective interaction-aware trajectory reconstruction method, which integrates vehicle interaction features with input-conditioned and conditional GAN models to achieve accurate and reliable trajectory reconstruction. By learning latent trajectory distributions, the proposed method enables efficient inference and achieves accurate longitudinal trajectory reconstruction on the real-world HighD dataset. Its effectiveness is further validated on the NGSIM dataset, where more congested traffic conditions, dense vehicle interactions, and complex longitudinal motion patterns pose greater reconstruction challenges. Under the challenging long blind-zone setting of 400 m, CITR-GAN achieves 2.43 m MAE, 3.69 m RMSE, and 1.60% MAPE, with a 19.0% MAE reduction over the best baseline method. Assuming a representative detector range of 250 m per site, it can potentially reduce detector density by up to 44.4% while maintaining blind-zone reconstruction capability. Results demonstrate that CITR-GAN not only improves reconstruction accuracy under challenging long blind-zone conditions but also provides a practical solution for enhancing sensing continuity with lower infrastructure requirements.

15 May 2026 in SSRN Electronic Journal
Verified
Preprint
Open access
YLYixin Li
Yixin Li
YNYing Ni
Ying Ni
XCXuejian Chen
Xuejian Chen
YZYujia Zhao
Yujia Zhao
CXCheng Xu
Cheng Xu
JSJian Sun
Jian Sun
Incorporation of more sophisticated human factors (HFs) into microscopic traffic simulation has become a mainstream research direction in recent years. Such models are believed to enable us to further improve the performance of simulation, and to understand the mechanisms behind many puzzling traffic phenomena. In this regard, it can not only provide more accurate traffic flow estimation for management and facility design, but also support the development of autonomous driving by providing more realistic virtual testing simulation environments in traffic. Although related discussions and models for the operational behaviour of drivers and pedestrians are already extensive, studies on incorporating HFs into microscopic simulation models of cyclists are still nascent. Most existing research still focuses on how different types, genders, and cycling styles affect interaction behaviour, and captures such characteristics by distinguishing values of model parameters. Solutions for endogenously representing and depicting human cycling behaviours remain very limited. This limitation brings bicycle simulation models’ inability in accurately capturing heterogeneous human cycling behaviours and the variation of interaction states generated by HFs, resulting in unsatisfactory simulation performance. To this end, we attempt to incorporate HFs into bicycle behaviour models to address this gap. In this paper, we first select a key HF, i.e., cycling capability, as the modelling attribute of cyclist, and accordingly propose a novel cycling “Demand-Capability” framework to endogenously quantify the influence of this HF attribute on cyclist interactions. Corresponding formulations are developed, and testing is carefully designed for the model validation. Then, we further integrate the above model into our previously developed two‑dimensional bicycle simulation model. Here, two dedicated approaches are correspondingly put forward to address the effects of HFs on the operational mental (decision) and operational physical (action) activities, respectively. Finally, we perform face validation of the proposed simulation model by comparing simulation results with observations obtained from the empirical trajectory dataset. Results show the proposed model outperforms its predecessors, especially in the presence of individual behaviour decisions and actions.