Eugen Gavan

Eugen Gavan

Auto-generated profile, based on publicly available information

Eugen Gavan


Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 December 2025 in Analele Universităţii "Dunărea de Jos" din Galaţi Fascicula XI Construcţii navale/ Annals of "Dunărea de Jos" of Galati Fascicle XI Shipbuilding
Verified
Journal Article
Closed access
DSDragoş Alexandru Saragea
Dragoş Alexandru Saragea
MDMarcel Drăgan
Marcel Drăgan
EGEugen Gavan
Eugen Gavan
Ion V. IonIon V. Ion
Ion V. Ion
The heat generated in the combustion inert gas generator (IGG) is usually discharged with flue gas cooling water. This paper proposes a system for recovering part of the heat generated in the IGG and using it in an absorption chiller for advanced cooling of the inert gas. The thermodynamic analysis showed that for an IGG consuming 240 kg/h of marine gas oil, 132 kW can be recovered to drive a lithium bromide-water absorption chiller, which can cool the inert gas down to 15°C, a temperature at which the water vapor content of the inert gas is 12.79 g/m3, much lower than if the inert gas is cooled only down to 50°C (82.5 g/m3) as it is done in most IGGs. By recovering waste heat, the quality of the inert gas is improved (humidity is reduced) without additional energy consumption.

13 December 2025 in Analele Universităţii "Dunărea de Jos" din Galaţi Fascicula XI Construcţii navale/ Annals of "Dunărea de Jos" of Galati Fascicle XI Shipbuilding
Verified
Journal Article
Closed access
ADAlina Descalui
Alina Descalui
CUCostel Ungureanu
Costel Ungureanu
CGCarmen-Marilena Gasparotti
Carmen-Marilena Gasparotti
EGEugen Gavan
Eugen Gavan
This paper presents the local structural analysis of a steel foundation supporting the pumps of a potable water system installed on a 30,000 DWT Handymax bulk carrier. The aim is to evaluate the structural behaviour of the foundation under static and dynamic loads representative for shipboard service and to propose simple constructive improvements that enhance stiffness and vibration performance. The potable water system is briefly described, including design requirements, sizing of the pumps, hydrophore unit and heat exchanger. The support structure is modelled in 3D CAD and analysed using the finite element method in ANSYS Mechanical, considering the mass of the pump unit and excitation frequencies up to 60 Hz. Three foundation variants are investigated: the initial design, a stiffened version obtained by adding local reinforcements and an alternative closed-section frame using rectangular hollow profiles. For each model, deformations and equivalent von Mises stresses are evaluated and compared with the yield limit of steel S235JR and with serviceability criteria from Eurocode 3. The results show that the optimized foundation with rectangular hollow sections significantly reduces maximum deformations and improves dynamic behaviour, without exceeding allowable stress levels. Recommendations for monitoring, maintenance and vibration isolation using spring-type anti-vibration mounts are also formulated.