1 January 2020 in Advances in Civil Engineering
According to the instability failure of the deep rock mass, a superposition block model of anomalously low‐friction effect was established. The numerical results were compared with the previous experiment, which verifies the feasibility and effectiveness of the simulation. A vertical impact and confining pressure were applied to the superimposed block model, and a horizontal static force was applied to the working block (the third block). This study aimed to determine the influence rules of vertical impact energy, confining pressure, and block lithology on the horizontal displacement of the working block and normal force on the contact surface. The results show that, with the increase of the vertical impact energy, the horizontal residual displacement of the working block increases linearly, and the horizontal displacement amplitude increases by the exponential function. The minimum normal force on the contact surface decreases linearly. As the confining pressure increases, the horizontal residual displacement of the working block decreases logarithmically, and the horizontal displacement amplitude decreases linearly. The minimum normal force on the contact surface increases linearly. The horizontal residual displacement and displacement amplitude of the working block in the coal‐rock combination are 1.51 times and 1.63 times of the rock mass, and the minimum normal force of the former is 0.84 times of the latter. Coal‐rock combination is more prone to the anomalously low‐friction effect than the rock mass.
1 December 2025 in Physica Scripta
The long-term stability of bedded rock slopes is usually dominated by properties of weak interlayers, which are prone to creep deformation and the resulting instability failure. Acting as potential sliding surfaces, weak interlayers can be destabilized by a combination of increasing stress, temperature fluctuations, and intense rainfall, ultimately leading to landslides. To investigate the internal instability mechanism of these layers in slopes and shear creep behavior of carbonaceous shale, the shear failure of carbonaceous shale was conducted by using a specialized shear rheology test system. The three stages of shear creep deformation were examined. Subsequently, a shear creep damage model for weak interlayers was established based on the theories of fractal derivatives and damage mechanics. Experimental results indicate that the shear creep rate increases with the increase of shear stress, but shear creep deformation decreases with the increase of normal stress. The time to creep failure of the sample is prolonged under higher normal stress, while determined by the shear stress and normal stress. Validation through experimental results shows that the shear creep model curves accurately capture the behavior of the test data. The research results have guiding significance for predicting the shear creep behavior of carbonaceous shale and long-term stability of weak interlayers in slope.
20 February 2026 in Physica Scripta
Carbonaceous shale weak layers are widely distributed in mine slopes. To better describe the entire shear creep response of carbonaceous shale under disturbance loads such as blasting and earthquakes, a full-stage nonlinear creep damage model induced by disturbance load was developed based on fractional-order theory. This model consists of a Hooke elastomer, a fractional-order Abel dashpot with damage induced by disturbance load, and a nonlinear viscoplastic damage model. It can comprehensively characterize the features of decelerating creep, steady-state creep, and accelerated creep, effectively reflecting the cumulative damage effect of the number of disturbances on rock shear creep. Shear creep tests were conducted on carbonaceous shale under different numbers of disturbances, and it was found that disturbance load significantly influenced its creep deformation and failure characteristics. The parameters of the creep model were identified using the Levenberg–Marquardt algorithm. A comparison with the classical Nishihara model further demonstrates that the fitted results of this model are highly consistent with test data across different numbers of disturbances, shear stress levels, and creep stages, validating the accuracy and rationality of the model. In addition, the model also demonstrates excellent adaptability in simulating the creep behavior of other rock materials under disturbance load conditions, providing methodological support for the long-term stability assessment of mine slopes under disturbance environments.