Unusual metastable paramagnetic phases have been observed in Fe–Cr thin films (thickness about 40 nm) fabricated by pulsed laser deposition. In the present article, x-ray diffraction and Mössbauer spectroscopy have been applied to follow the structural and magnetic phase transformation in these alloys induced by ion irradiation with a projected range positioned in the center of the films. It has been found that the critical dose for the transformation to the more stable body-centered cubic (bcc) structure depends on the initial phase of the film and the ion mass. The initial body-centered tetragonal phase, which forms in the alloys with low Cr content (∼30 at. %), can be completely transformed to the bcc phase already by a dose of 5×1015 Cr/cm2, whereas the primitive orthorhombic phase of roughly equiatomic Fe–Cr alloys is about four times more resistant against ion bombardment. A five times higher Ne ion dose is required to induce the same transformation as by the Cr bombardment. The observed effects are discussed in view of radiation damage caused by the different ions and the grade of affinity of the initial phase to the bcc one.
Iron implanted and subsequently annealed n‐type Si(111) was studied by conversion electron Mössbauer spectroscopy and Auger electron spectroscopy. Results of Mössbauer spectroscopy indicate the formation of a mixture of β‐ and α‐FeSi2 due to the implantation and a complete transition of the mixture to the β and the α phase after annealing at 900 °C for 18 h and 1150 °C for 1 h, respectively. The iron concentration profiles determined with Auger electron sputter depth profiling are Gaussian shaped for the as‐implanted and broadened with depth depending fluctuations for the annealed samples. Investigations of the annealed samples with scanning Auger electron spectroscopy show the formation of large precipitates with, depending on the annealing procedure, different structures.
14 June 2019 in Journal of Vacuum Science & Technology B
High temperature nitrogen plasma immersion ion implantation (HT-NPIII) method was used to treat the internal walls of small diameter metal tubes made of SS304 and of Ti6-Al4-V (TAV). Using a lid in one side of the tubes was essential to reach high temperatures of 700–900 °C, necessary for high thermal diffusion of nitrogen in Ti alloy samples placed inside the metal tubes for monitoring the HT-NPIII process. The used metal tubes also reached such high temperatures. New phases of TiN and Ti2N were successfully attained in the TAV samples with the treated layer thickness of more than 1.3 μm for all the tested cases. For tubes made of SS304, HT-NPIII treatments resulted in redeposition of FeN thick layers with high hardness on the surfaces of the internal walls of the tubes and on the monitoring samples. Obtaining such HT-NPIII conditions in these small metallic tubes was possible by achieving high plasma density through hollow cathode discharges inside those tubes. These results were compared to the ones obtained on the nitrogen implantation treatments of TAV samples in moderate to high temperatures carried out previously in the laboratory which indicated the superior performance of the presently reported method of surface modification.
1 April 2001 in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms