6 October 2014 in Soft Matter
The recently proposed nonlocal granular fluidity model provides a quantitative description of flows of granular media down a rough inclined plane.
20 October 2014 in Physical Review Letters
Recent dense granular flow experiments have shown that shear deformation in one region of a granular medium fluidizes its entirety, including regions far from the sheared zone, effectively erasing the yield condition everywhere. This enables slow creep deformation to occur when an external force is applied to a probe in the nominally static regions of the material. The apparent change in rheology induced by far-away motion is termed the “secondary rheology,” and a theoretical rationalization of this phenomenon is needed. Recently, a new nonlocal granular rheology was successfully used to predict steady granular flow fields, including grain-size-dependent shear-band widths in a wide variety of flow configurations. We show that the nonlocal fluidity model is also capable of capturing secondary rheology. Specifically, we explore creep of a circular intruder in a two-dimensional annular Couette cell and show that the model captures all salient features observed in experiments, including both the rate-independent nature of creep for sufficiently slow driving rates and the faster-than-linear increase in the creep speed with the force applied to the intruder.
1 November 2019 in Physics in Medicine & Biology
The destructive growth and collapse of cavitation bubbles are used for therapeutic purposes in focused ultrasound procedures and can contribute to tissue damage in traumatic injuries. Histotripsy is a focused ultrasound procedure that relies on controlled cavitation to homogenize soft tissue. Experimental studies of histotripsy cavitation have shown that the extent of ablation in different tissues depends on tissue mechanical properties and waveform parameters. Variable tissue susceptibility to the large stresses, strains, and strain rates developed by cavitation bubbles has been suggested as a basis for localized liver tumor treatments that spare large vessels and bile ducts. However, field quantities developed within microns of cavitation bubbles are too localized and transient to measure in experiments. Previous numerical studies have attempted to circumvent this challenge but made limited use of realistic tissue property data. In this study, numerical simulations are used to calculate stress, strain, and strain rate fields produced by bubble oscillation under histotripsy forcing in a variety of tissues with literature-sourced viscoelastic and acoustic properties. Strain field calculations are then used to predict a theoretical damage radius using tissue ultimate strain data. Simulation results support the hypothesis that differential tissue responses could be used to design tissue-selective treatments. Results agree with studies correlating tissue ultimate fractional strain with resistance to histotripsy ablation and are also consistent with experiments demonstrating smaller lesion size under exposure to higher frequency waveforms. Methods presented in this study provide an approach for modeling tissue-selective cavitation damage in general.
13 November 2013 in Soft Matter
Surface energy is an important factor in the deformation of fluids but is typically a minimal or negligible effect in solids. However, when a solid is soft and its characteristic dimension is small, forces due to surface energy can become important and induce significant elastic deformation. The interplay between surface energy and elasticity can lead to interesting elasto-capillary phenomena. We present a finite-element-based numerical simulation capability for modeling these effects in a static, implicit framework. We demonstrate the capacity of the simulation capability by examining three elasto-capillary problems: (i) wetting of an elastic hemispherical droplet on a substrate, (ii) cavitation of an elastomer, and (iii) the Rayleigh–Plateau instability in soft elastic filaments.
1 October 2018 in International Journal of Solids and Structures
13 October 2017 in Journal of Fluid Mechanics
Dense granular heap flows are common in nature, such as during avalanches and landslides, as well as in industrial flows. In granular heap flows, rapid flow is localized near the free surface with the thickness of the rapidly flowing layer dependent on the overall flow rate. In the region deep beneath the surface, exponentially decaying creeping flow dominates with characteristic decay length depending only on the geometry and not the overall flow rate. Existing continuum models for dense granular flow based upon local constitutive equations are not able to simultaneously predict both of these experimentally observed features – failing to even predict the existence of creeping flow beneath the surface. In this work, we apply a scale-dependent continuum approach – the non-local granular fluidity model – to steady, dense granular flows on a heap between two smooth, frictional side walls. We show that the model captures the salient features of both the flow-rate-dependent, rapidly flowing surface layer and the flow-rate-independent, slowly creeping bulk under steady flow conditions.