1 January 2017 in Soil Dynamics and Earthquake Engineering
Uniform cyclic loading is commonly used in laboratory tests to evaluate soil resistance to earthquake-induced liquefaction, even if the cyclic stresses induced by earthquakes in the field are highly irregular. This paper discusses the use of stress and energy-based approaches to evaluate the liquefaction resistance of sand under irregular loading. Results of undrained cyclic triaxial tests including a large-amplitude singular peak loading cycle are presented and compared to those obtained using uniform loading. Although samples are subjected to loading patterns which would have been deemed equivalent by conventional stress-based methods, the number of cycles required to trigger liquefaction strongly depends on the amplitude and location of the peak within the loading history. Conversely, a unique relationship exists between the accumulation of dissipated energy per unit volume, computed using stress and strain measurements, and the observed residual pore water pressure build-up for all tests, throughout the entire cyclic loading application. This demonstrates that conventional laboratory tests using uniform loading conditions can be employed to determine liquefaction resistance if their interpretation is carried out based on energy principles
1 May 2017 in Journal of Geotechnical and Geoenvironmental Engineering
A series of bender element tests and drained and undrained monotonic triaxial compression and extension tests were performed on air-pluviated samples of Hostun sand. Samples were prepared to different initial void ratios, consolidated under various isotropic and anisotropic stress states, and sheared using different stress paths and a wide range of deformations to characterize the sand’s stress-strain response. The results suggest that the sand’s small-strain behavior essentially depends on the current void ratio and mean effective stress. Within the medium to large strain range, a state-parameter approach in conjunction with the critical-state framework can successfully predict the distinctive states of the sand’s monotonic response, namely the phase-transformation, peak-stress-ratio, and critical states. Furthermore, the data are used to examine a stress-dilatancy relationship often incorporated in constitutive models. The characterization presented herein aims at assisting the efficient calibration of numerical models and provides insight into this sand’s behavior, thus supporting the interpretation of results of physical modeling involving this sand. This paper highlights the importance of characterizing sand’s behavior over the full strain range and shows that accurate predictions of the critical state and small-strain stiffness are crucial to assess other aspects of the sand’s behavior.
27 July 2022 in Soils and Rocks
JSJorge N. V. Almeida e Sousa
Jorge N. V. Almeida e Sousa
In big cities the construction of new tunnels in close proximity to existing ones is unavoidable given the densely and growing occupation of the subsoil. The interaction between tunnels in such conditions is well identified in the literature and has been thoroughly investigated in the past. However, most of those studies are focused on the effect of the ground conditions and relative position between tunnels on the ground movements and often disregard the impact induced by the second excavation on the lining forces of both tunnels. To provide further insight into this subject a numerical study of the sequential excavation of side-by-side twin tunnels is presented in this paper. The study also assesses the influence of parameters that have not been covered in the previous studies, namely the stiffness of the lining and the initial stress conditions. The results confirm that significant interaction occurs when the tunnels are spaced less than one diameter, where a considerable increase on both hoop forces and bending moments, particularly on the lining of the existing tunnel, is observed after the second excavation. For a spacing higher than two diameters the interaction between tunnels is almost negligible. The magnitude of the lining forces and of the interaction effects are also dependent of the stiffness of the linings and of the initial stress conditions.