1 September 2021 in Energy
1 January 2020 in Structural Durability & Health Monitoring
The buoyancy of groundwater can reduce the foundation bearing capacity and cause the metro tunnels to float as a whole, which threatens the safety of structures seriously. Therefore, uplift piles are set up to improve the structural stability. In this paper, FLAC3D software is used to establish the calculation models of pile foundation. The bearing failure process of uplift piles was simulated to study the influencing factors on single pile load bearing capacity as well as the cooperative work laws of pile groups. The load-displacement curves of pile top under different length-diameter ratios, pile-soil interface characteristics and pile types are obtained, respectively. The results showed that, increasing the lengthdiameter ratio and the pile-soil interface roughness properly can improve the bearing capacity of uplift piles. Besides, changing the shapes of constant pile section can also improve it, which has the most significant effect concerning of saving material cost. In the loading process of pile groups, the ultimate bearing capacity of corner pile is the biggest, the side pile is the next, and the center pile is the smallest. The deformation characteristics of pile top are as follows: the center pile is the biggest, the side pile is the next, and corner pile is the smallest. Combined with the results, the uplift resistance of group piles can be enhanced pertinently, and the conclusions provide guidance for the design and construction of uplift piles in the actual engineer.
26 August 2022 in Journal of Advanced Transportation
Modeling and control of road traffic in large-scale urban networks present considerable challenges. The traffic equilibrium phenomena, with the question of route choice behavior in case of heterogeneous urban networks, has not been thoroughly investigated in parsimonious and classical models due to the limitation, like large network size, spatiotemporal propagation of congestion, and the interaction between driver decisions, etc. In this paper, we propose a bi-level approximating dynamic equilibrium model (BLADEM) for the approximating dynamic equilibrium analysis in multi-region network based on macroscopic fundamental diagram (MFD). The proposed model combines the region-based model and the internal-region model. With the information from region MFD, the region-based model is used to implement the time-dependent regional route choice estimation. Traffic equilibrium condition (dynamic user equilibrium, DUE) is considered in an internal-region model with time-aggregated regional OD demand from the region level. Furthermore, the complexity of the proposed model is derived. Then, the comparative analysis of the algorithm complexity between the proposed model and the DUE model is given. The proposed model is evaluated based on the high-resolution vehicle trajectory data (or connected vehicles trajectory data) from the DiDi platform collected in Chengdu, China with more than 3,000,000 GPS points during a typical workday. The evaluation results show that the proposed model can obtain the approximating traffic dynamics compared with the DUE algorithm. Pleasantly, the improved calculation efficiency is between 21% and 42%. The results indicate the promising potential of using the proposed model to analyze approximating dynamic equilibrium in the multi-region heterogeneous network.
16 September 2022 in Journal of Advanced Transportation
Freeway on-ramp merging area is deemed to be typical bottlenecks section, which leads to low traffic efficiency, congestions, and frequent accidents. Most existing studies on merging for the connected and automated vehicles focus on merging at a single fixed merging point. However, the problem of coordination between merging vehicle and arterial traffic flow in the acceleration lane is ignored in the existing studies. This study proposes a merging model, which combined safety and coordination of CAVs with featuring optimal merging positions. The proposed model has two stages: one is analysis of merging velocity of the insertable gap and the other one is determining constraint condition of cooperative merging. The outputs of first stage are interval of merging speed and the mergeable range. The outputs of second stage are optional insertable gap and the corresponding driving scheme. Then, a traffic simulation experiment is designed to evaluate the proposed model. The simulation results show that the proposed model can effectively guarantee driving safety and make the merging process smoother with 28.7% reduction in travel time for the CAV merging. Furthermore, the proposed model does not sacrifice the interests of surrounding traffic to assist in CAV merging. The results indicate the promising potential of using the proposed methods can approximately get a fair use of road resources for each CAV.