We propose a numerical self-consistent method for 3D classical lattice models, which optimizes the variational state written as two-dimensional product of tensors. The variational partition function is calculated by the corner transfer matrix renormalization group (CTMRG), which is a variant of the density matrix renormalization group (DMRG). Numerical efficiency of the method is observed via its application to the 3D Ising model.Comment: 9 pages, 4 figures, submitted to Prog. Theor. Phy
The quasistable state in the photoinduced phase transition for the quasi-one-dimensional quarter-filled organic conductor has been examined by ultrafast reflective measurements and time-dependent model calculations incorporating both electron-electron and electron-phonon interactions. The transient optical conductivity spectrum over a wide probe photon-energy range revealed that photoexcitation induced a new type of charge-disproportionate state. Additionally, coherent and incoherent oscillations dependent on probe photon energies were found, as predicted by the calculation.
We present a new algorithm to calculate the thermodynamic quantities of three-dimensional (3D) classical statistical systems, based on the ideas of the tensor product state and the density matrix renormalization group. We represent the maximum-eigenvalue eigenstate of the transfer matrix as the product of local tensors that are iteratively optimized by the use of the “vertical density matrix” formed by cutting the system along the transfer direction. This algorithm, which we call vertical density matrix algorithm (VDMA), is successfully applied to the 3D Ising model. Using the Suzuki-Trotter transformation, we can also apply the VDMA to 2D quantum systems, which we demonstrate for the 2D transverse field Ising model.
We consider a variational problem for three-dimensional (3D) classical lattice models. We construct the trial state as a two-dimensional product of local variational weights that contain auxiliary variables. We propose a stable numerical algorithm for the maximization of the variational partition function per layer. The numerical stability and efficiency of the new method are examined through its application to the 3D Ising model.Comment: 9 pages, 5 figures, in LaTex2e style. accepted for publication in Prog. Theor. Phys. 11
1 October 2005 in Journal of the Physical Society of Japan
We study photoinduced optical responses of one-dimensional strongly correlated electron systems. The optical conductivity spectra are calculated for the ground state and a photoexcited state in the one-dimensional Hubbard model at half filling by using the exact diagonalization method. It is found that, in the Mott insulator phase, the photoexcited state has large spectral weights including the Drude weight below the optical gap. As a consequence, the spectral weight above the optical gap is largely reduced. These results imply that a metallic state is induced by photoexcitation. Comparison between the photoexcited and hole-doped states shows that the photoexcitation is similar to chemical doping.