1 July 2020 in Physics of Plasmas
Pulsed power accelerators compress electrical energy in space and time to provide versatile experimental platforms for high energy density and inertial confinement fusion science. The 80-TW “Z” pulsed power facility at Sandia National Laboratories is the largest pulsed power device in the world today. Z discharges up to 22 MJ of energy stored in its capacitor banks into a current pulse that rises in 100 ns and peaks at a current as high as 30 MA in low-inductance cylindrical targets. Considerable progress has been made over the past 15 years in the use of pulsed power as a precision scientific tool. This paper reviews developments at Sandia in inertial confinement fusion, dynamic materials science, x-ray radiation science, and pulsed power engineering, with an emphasis on progress since a previous review of research on Z in Physics of Plasmas in 2005.
1 April 2008 in Physics of Plasmas
Approximate lower bounds for the kinetic energy and magnetic flux dissipation for tungsten wire arrays on the Z pulsed-power accelerator at Sandia National Laboratories [R. B. Spielman et al., Phys. Plasmas 5, 2105 (1998)] are obtained. A procedure, extending previous work determining pinch inductance as a function of time [E. M. Waisman et al., Phys. Plasmas 11, 2009 (2004)], is introduced and applied to electrical and x-ray energy measurements. It employs the pinch energy balance to determine lower bounds for the plasma kinetic energy just before the main pinch reaches the axis and for the magnetic flux dissipation during stagnation. From the lower bound for the dissipated flux, a lower bound for pinch resistance after x-ray peak power is estimated. The results of applying the introduced energy balance procedure to selected tungsten wire array implosions on Z are given. It is believed that this is the first time that a measure of wire array Z-pinch resistance at stagnation is obtained purely from data analysis without recourse to specific assumptions on the plasma motion.
1 June 2018 in Physics of Plasmas
By deploying a photon Doppler velocimetry based plasma diagnostic, we have directly observed low density plasma in the load anode/cathode gap of cylindrically converging pulsed power targets. The arrival of this plasma is temporally correlated with gross current loss and subtle power flow differences between the anode and the cathode. The density is in the range where Hall terms in the electromagnetic equations are relevant, but this physics is lacking in the magnetohydrodynamics codes commonly used to design, analyze, and optimize pulsed power experiments. The present work presents evidence of the importance of physics beyond traditional resistive magnetohydrodynamics for the design of pulsed power targets and drivers.
1 August 2003 in Physics of Plasmas
The axial radiation developed primarily from the interior of an imploding dynamic hohlraum (DH) target within a Z pinch using a single array with a large number of tungsten wires is compared with that generated using a standard [Phys. Plasmas 9, 3573 (2002)] nested (outer plus inner) array on Z. Measurements indicate that a single-array with a mass (2.5 mg) near that of the combined mass of the nested-array maximizes the DH axial power. At this mass, the DH utilizing the standard nested array generates (23±15)% more axial power than that of a single array. Measurements over a range of single-array masses (2–6 mg) show a decrease in radiation power for masses above 3.5 mg. Two-dimensional radiation magnetohydrodynamic simulations, which have successfully described radial emission from targetless implosions for both single and nested-array configurations [Phys. Plasmas 6, 2178 (1999)], however, do not follow the observed trends well. This lack of tracking implies that current 2D models, which take into account the development of the magnetic Rayleigh–Taylor (RT) instability in the r–z plane, require improvements in order to provide a self-consistent description of the implosion dynamics and radiation production for DH experiments.