Poly‐γ‐glutamic acid (γ‐PGA) is a biopolymer with a wide range of applications, mainly produced using Bacillus strains. The formation and concomitant secretion of γ‐PGA increases the culture broth viscosity, while enzymatic depolymerisation and degradation of γ‐PGA decreases the culture broth viscosity. In this study, the recently published ViMOS ( V iscosity M onitoring O nline S ystem) is applied for optical online measurements of broth viscosity in eight parallel shake flasks. It is shown that the ViMOS is suitable to monitor γ‐PGA production and degradation online in shake flasks. This online monitoring enables the detailed analysis of the P pst promoter and γ‐PGA depolymerase knockout mutants in genetically modified Bacillus subtilis 168. The P pst promoter becomes active under phosphate starvation. The different single depolymerase knockout mutants are ∆ggt , ∆pgdS , ∆cwlO and a triple knockout mutant. An increase in γ‐PGA yield in g γ‐PGA /g glucose of 190% could be achieved with the triple knockout mutant compared to the P pst reference strain. The single cwlO knockout also increased γ‐PGA production, while the other single knockouts of ggt and pgdS showed no impact. Partial depolymerisation of γ‐PGA occurred despite the triple knockout. The online measured data are confirmed with offline measurements. The online viscosity system directly reflects γ‐PGA synthesis, γ‐PGA depolymerisation, and changes in the molecular weight. Thus, the ViMOS has great potential to rapidly gain detailed and reliable information about new strains and cultivation conditions. The broadened knowledge will facilitate the further optimization of γ‐PGA production.
Shake flasks are one of the most widely used cultivation vessels in biotechnological process development. To improve the process understanding, new technologies have been reported for online monitoring of different parameters like oxygen, pH, or biomass in the last couple of years. However, most reports address the monitoring of a single parameter per shake flask. This work evaluates the ability to measure dissolved oxygen (DO), biomass, and fluorescence in parallel with a new Multiparameter Sensor (MPS). Therefore, abiotic tests for reproducibility, sensitivity, and accuracy were performed. In biological tests, different microbial systems were used to evaluate if a wide range of applications is feasible. This work demonstrates that three different parameters: DO, biomass, and fluorescence can be monitored online, in parallel, for various biological systems. The online data obtained provide crucial process knowledge, such as the start of intracellular product formation. Abiotic and biological tests showed good reproducibility, resolution, and sensitivity to changing environmental conditions. Compared to other existing measurement systems for DO or oxygen transfer rate, similar or in the former case, more data points can be recorded, allowing a detailed overview and a better understanding of the process.