Doping of the materials with other metals or transition metals will modify the properties of the nanomaterials. In this work, MgO and Cu doped MgO which are Mg0.95Cu0.05O and Mg0.90Cu0.10O nanomaterials are synthesized using a self-propagating combustion method. The samples are annealed at 900 °C for 24 hours. The phase and purity of the synthesized samples are studied using X-Ray Diffraction (XRD) and the result revealed that the samples are pure and single phase. The morphology and crystallite size of the pure samples are examined using Field Emission Scanning Electron Microscope (FESEM). The result shows polyhedral morphology with agglomeration of crystallite and average crystallite size of the samples is between 40 to 210 nm. The band gap obtained for MgO nanostructures is 6.38 eV which is lower than bulk MgO of 7.8 eV. The presence of Cu causes the narrowing the band gap energy of Mg0.95Cu0.05O and Mg0.90Cu0.10O samples to 4.28 eV and 3.35 eV respectively.
NMC 111 cathode materials exhibit engaging properties in high energy density and low cost, making it great potential for the next generation of high-energy lithium-ion batteries. However, it still faces challenges such as fast capacity fade, especially at high C rates. Herein, we implement the novel Ti-doped cathode material, LiNi0.3Mn0.3Co0.3Ti0.1O2 (NMCT) synthesized via the combustion method. It was discovered that NMCT can effectively improve capacity delivery at high C rates. The T80 material demonstrated superior electrochemical annealed at 800 ˚C for 72 h, with an exceptional specific discharge capacity of 148.6 mAh g-1 and excellent cycle stability (capacity retention 96.8 %) after 30th cycles at 3 C. The results demonstrated that Ti-doped NMC had superior advantages for LiNi1/3Mn1/3Co1/3O2 (NMC 111) material at the optimum temperature of 800 °C for 72 h. It is one of the potential cathode materials for Li-ion batteries.
5 December 2025 in Journal of Electrochemical Science and Engineering
Optimizing the electrochemical performance of nickel-rich cathode materials, specifically Ni0.8Mn0.1Co0.1(OH)2 (NMC811) precursors, involves careful adjustment of several factors, including modification, calcination temperature and lithium content. In this study, we explored the influence of lithium content on the structural, morphological and electrochemical performances of LixNi0.8Co0.1Mn0.1O2, by varying 5, 10, 15 and 20 mol.% of Li excess. An appropriate amount of Li was found to suppress cation mixing effectively. Rietveld refinement showed that increasing Li content gradually reduced cation mixing by enhancing the occupancy of Li⁺ ions at the 3a sites, thereby hindering Ni²⁺ migration. Although a higher Li addition (20 mol.%) induced a slight lattice contraction, it exhibited the highest c/a ratio (the ratio of the lattice parameters c and a in the layered hexagonal structure), indicative of a well-ordered layered structure. Furthermore, Li exceeded 20 mol.% suppressed the H2/H3 phase transition, contributing to greater structural stability during cycling. While 15 mol.% Li excess achieved the highest initial discharge capacity (185.42 mAh g-1 at 0.1 C), 20 mol.% Li excess exhibited superior capacity retention (82.05 % over 80 cycles at 0.1 C). These results demonstrate the critical role of lithium stoichiometry in maintaining structural integrity and electrochemical stability of Ni-rich NMC cathodes, offering valuable insights for the design of high-performance lithium-ion batteries.