Self-cleaning surfaces have excelled in recent years in energy and environmental fields. In particular, in solar energy area, these surfaces are used to avoid soiling accumulation on photovoltaic (PV) modules. So far TiO2 has been widely used due to its photocatalytic activity and photo-induced superhydrophilicity. However, this oxide has some limitations since it reduces the glass transmittance and it rapidly reestablish the water contact angle in dark environments. In order to circumvent these limitations, composites TiO2/SiO2 have been proposed. For photovoltaic application, besides a good transparency in the wavelength region 300–1800 nm and self-cleaning properties, the coating should also present long durability and adequate adhesion to endure the outdoor conditions. Aiming at developing a coating with these properties, in this work, TiO2/SiO2 composites containing different titanium content have been synthesized and compared with pure TiO2 films in relation to adhesion, transparency and hydrophilicity. Both films have been deposited over low iron float glass substrates by sol–gel dip-coating technique and different calcination temperatures (400, 500, 600°C) and Si/Ti molar rates (Si86Ti14, Si40Ti60) have been considered. TiO2/SiO2 films showed higher transmittance in visible range compared with pure TiO2. TiO2/SiO2 films showed superhydrophilic character before and after ultraviolet irradiation, with water contact angles near to 0°. Furthermore, as predicted, TiO2/SiO2 films could keep the superhydrophilic character in dark environments, in contrast with pure TiO2 films. Both TiO2 and TiO2/SiO2 films exhibited good adherence and it is shown that higher calcination temperatures and higher titanium content enhance such property. All films presented abrasion resistant property in contact with sponge and detergent. It has been demonstrated that high transmittance, self-cleaning and adherent composite has been obtained by a simple sol–gel route presenting good potential to be applied on photovoltaics systems.
1 October 2018 in Solar Energy Materials and Solar Cells
Magnetic nanoparticles can improve the efficiency of phase separation time in multi-stage operations when a magnetic field is present. As such operations involve contact with aqueous and/or organic solutions, hydrophilic magnetic nanoparticles synthesized through the co-precipitation method were functionalized with oleic acid to attain hydrophobic magnetic nanoparticles. Both nanoparticles were characterized morphologically, chemically and magnetically. The results revealed that the particles (size ≈ 10 nm) consisted of an iron oxide mixture of magnetite and maghemite. The functionalization with oleic acid was effective in converting them into hydrophobic nanoparticles. Both particles were ferro/ferrimagnetic and the presence of oleic acid did not interfere significantly in the saturation magnetization value. The chemical stability of both nanoparticles were also evaluated, as an attempt of simulating broad industrial conditions to which the nanoparticles may be subjected; the hydrophilic nanoparticles were resistant at pH ≥ 4, while the hydrophobic nanoparticles were stable at pH ≥ 3.
Magnetite nanosized particles synthesis was achieved by two different routes. Assessment of microstructure was carried out aiming at comparing the outcome of synthesis parameters on the crystallinity, distribution of particle dimension and magnetic activity of nanosized particles precipitated in aqueous solution. Increasing of the nanoparticles crystallite size by stirring could be evidenced by the results. Temperature does not significantly affect crystallite size and crystallinity. The type of precursor was the factor that most contributed to the definition of crystallinity and particle size distribution. The route which used FeSO4.7H2O as precursor favored large crystallite sizes and crystallinity, while the route which used Fe2SO4.7H2O and FeCl3.6H2O as precursors resulted in much smaller crystallite sizes and crystallinity.