The tunnel-following nonlinear model predictive control (NMPC) scheme allows to exploit acceptable deviations around a path reference. This is done by using convex-over-nonlinear functions as objective and constraints in the underlying optimal control problem (OCP). The convex-over-nonlinear structure is exploited by algorithms such as the generalized Gauss-Newton (GGN) method or the sequential convex quadratic programming (SCQP) method to reduce the computational complexity of the OCP solution. However, the modeling effort and engineering time required to implement these methods is high. We address the problem of reducing the modeling effort in the implementation of SCQP, focusing on a standard sequential quadratic programming (SQP) implementation where symbolic linearization is applied to the nonlinear part of the convex-over-nonlinear functions in the objective and constraints. The novelty of this letter is twofold. It introduces a novel operator that applies symbolic linearization in a transparent and easy way to solve nonconvex OCPs with the SCQP method, and introduces a meaningful representation of an orientation-tunnel for robotic applications by means of a convex-over-nonlinear constraint, which preserves the convexity exploitation by the SCQP method. The proposed technique is demonstrated in a tunnel-following task for a 7-degrees-of-freedom manipulator.
This paper presents the design and implementation of Android-based cascade PID controller structures to control the altitude and attitude of a quadcopter, and the sensor fusion algorithms implemented to estimate its flight dynamics. The main goal of this research is to stabilize the attitude of an unmanned aerial vehicle (UAV), such as a quadcopter, and control its altitude using exclusively the sensors and processor of a smartphone on-board. As the sensors embedded in the smartphones are not accurate enough to measure the altitude of the quadcopter, a linear Kalman filter for relative altitude estimation was designed and implemented. Here, it is described precisely the hardware that was used to build the test platform, the non-linear an linearized quadcopter model, the software structure to execute the controllers in the smartphone, the sensor fusion algorithms implemented to obtain reliable data from the smartphone sensors, and the cascade PID controllers design. Finally, the success of the proposed system is evidenced in the results of a set of experimental tests. In these tests, the quadcopter attitude was regulated after some disturbances were applied to the system and its altitude was controlled after the reference was changed.
In this paper, a flight control system for a smartphone-based quadrotor is proposed. The sensing, the state estimation and control algorithms in this quadrotor are exclusively executed by the smartphone on-board. Two control architectures for this quadrotor are here presented: a LQG controller with gain compensation for reference tracking and a controller. Due to the shortcomings of smartphones' sensors, a Kalman filter for state estimation is proposed. We also present simulation results of the proposed system using dynamic models and real quadrotor parameters. These results demonstrate the performance advantages of the LQG and controllers. An absolute error of less than 2.4 ± 0.001 m while take-off and landing, and 1.1 ± 0.001 m while following a mission path is achieved.
27 June 2023 in International Journal of Online and Biomedical Engineering (iJOE)
This paper presents a wearable virtual reality system with a wireless network of inertial sensors for lower limb monitoring. The system comprises seven sensor nodes sending data wirelessly to a master node. The information is then collected, organized, and sent to a screening device via a serial interface. An application executed either on a smartphone or a personal computer features an avatar which represents the received data and mimics the sensed movements of the patient, providing online feedback during and after the execution of a therapy. The data resulting from the therapy execution can be uploaded to a web server to facilitate the assessment and decision-making by health professionals. A pendulum featuring a rotary optical encoder is used for sensor functional behavior validation. In addition, the orientation angles measured by the proposed system are compared with respect to measurements from the motion analysis software Kinovea. The delay between the patient's body movement and the avatar is 33 ms, which is acceptable for visual feedback. This system is portable, inexpensive and enables a patient to complete physical therapy sessions at home or anywhere, with the advantage of enabling visual feedback through an avatar during rehabilitation therapy and allowing the reproduction of a therapy session for further analysis.