10 February 2015 in The International Journal of Advanced Manufacturing Technology
24 April 2010 in The International Journal of Advanced Manufacturing Technology
6 November 2021 in The International Journal of Advanced Manufacturing Technology
24 January 2012 in Advanced Materials Research
In machining processes, great amount of the cutting energy transforms to heat energy. Tool life decreases and the quality of the machined surface changes by the effects of heat during machining. Many researches are being done on the reduction of the negative effects of the heat on the tool. In this respect, cutting fluids are used, but usages of them are limited because of their some harmfully effects to the environment. In order to reduce the tool wear and to use the tool longer, during cutting continuously variation of the contact region of the tool and the chip can been realized by using self-propelled rotary tools. The tool life is longer in rotary tools when compared with stationary cutting tools. In machining with these tools lower heat effect at the cutting edge is observed. In this study, the effects of cutting parameters on surface roughness of machined part has been investigated during the turning of mild steel using self-propelled rotary tools. In experiments, cutting tools which inclination angles were 20°, 30° and 45° and rake angles were 0° and-5° were used. Cutting speeds were taken as 60 m/min and 120m/min. RCMX insert with 32mm diameter was used. Feed were chosen as 0.1, 0.2 and 0.4 mm/rev and cutting depth was set at 0.25 mm.
11 April 2023 in Journal of Thermal Engineering
The milling is a widely used method in the manufacturing industry, especially in the production of complex engravings such as die&molds. Rough milling often requires a large material removal rate in a short time. This purpose also requires the selection and use of the best milling tool path. Today, trochoidal milling is receiving more attention than conventional milling, especially as it significantly increases tool life. In this study, a new toolpath model for trochoidal milling is suggested and this proposed toolpath model is examined in terms of cutting temperature, cutting force, surface quality, tool wear. In this new trochoidal toolpath model proposed for the milling method, the cutting force did not change much compared to the standard trochoidal tool path, but better surface quality and less tool wear were observed.
1 January 2012 in Advanced Materials Research