Purpose: The purpose of this paper is to study thickness dependent variation in microwave properties of the MgxMn(0.9−x)Al0.1Zn0.8Fe1.2O4 (x=0.8, 0.9) thick films and enhancement of power efficiency of Ag thick film EMC patch antenna.Design/methodology/approach: X‐band microwave properties of the MgxMn(0.9−x)Al0.1Zn0.8Fe1.2O4 (x=0.8, 0.9) thick films were measured by superstrate technique using Ag thick film EMC patch antenna as the resonant element. The complex permittivity and permeability of these thick films were also measured by this technique. The microwave response of the EMC patch, complex permeability and permittivity of Mg0.8Mn0.1Al0.1Zn0.8Fe1.2O4 and Mg0.9Al0.1Zn0.8Fe1.2O4 thick films and their thickness dependency were investigated.Findings: The XRD patterns reveal the cubic spinel crystal system was obtained for both compositions. The crystallite size obtained was 134.68 nm for Mg0.8Mn0.1Al0.1Zn0.8Fe1.2O4 and 155.99 nm for Mg0.9Al0.1Zn0.8Fe1.2O4 The superstrate technique has been used successfully to evaluate the complex permittivity and permeability of the ferrite thick films in the X band. The EMC patch also show thickness and composition dependent frequency agility and enhancement of power efficiency.Originality/value: The complex permeability of MgxMn(0.9−x)Al0.1Zn0.8Fe1.2O4 (x=0.8, 0.9) thick films measured by superstrate technique is reported in this paper. The superstrate of MgxMn(0.9−x)Al0.1Zn0.8Fe1.2O4 (x=0.8, 0.9) thick films makes the Ag thick film EMC patch antenna frequency agile and power amplification is obtained.
The present Letter deals with the investigation on the synthesis and properties of nanostructured mixed barium hexaferrites of M-type (BaFe12O19) and Y-type (Ba2Co2Fe12O22). The nanoparticles of mixed hexaferrite (Ba–M–Y) were obtained using co-precipitation technique with and without addition of polyethylene Glycol (PEG) during synthesis. The precipitate was calcined at 600°C for 6 h and characterised for structural, morphological, electrical and microwave properties. PEG acts as a template for the formation of hexaferrite nanoparticles. Significant reduction in crystallite size and grain size was obtained for Ba–M–Y synthesised in the presence of PEG template. Owing to PEG template the temperature-dependent resistivity showed negative temperature coefficient properties whereas without PEG the Ba–M–Y showed positive temperature coefficient properties. The microwave dielectric constant of Ba–M–Y–PEG (5.5 at 10.4 GHz) was higher than that of Ba–M–Y (4.1 at 10.4 GHz). Owing to PEG the microwave absorption increases to almost 50% from less than 1% in the10–10.7 GHz range.