Hélène Lyon-Caen

Hélène Lyon-Caen

Auto-generated profile, based on publicly available information

Hélène Lyon-Caen

Ecole Normale Supérieure, PSL University, CNRS, UMR 8538 - Laboratoire de Géologie, 24 rue Lhomond, 75005 Paris, France

Research Focus & Metrics

Academic Career Length

44Years (1983-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 April 2012 in Journal of Geophysical Research
Verified
Journal Article
Open access
PDF file
TAThomas Ader
Thomas Ader
Jean-Philippe AvouacJean-Philippe Avouac
Jean-Philippe Avouac
JLJing Liu
Jing Liu
HLHélène Lyon‐Caen
Hélène Lyon‐Caen
LBLaurent Bollinger
Laurent Bollinger
MFMireille Flouzat
Mireille Flouzat
We document geodetic strain across the Nepal Himalaya using GPS times series from 30 stations in Nepal and southern Tibet, in addition to previously published campaign GPS points and leveling data and determine the pattern of interseismic coupling on the Main Himalayan Thrust fault (MHT). The noise on the daily GPS positions is modeled as a combination of white and colored noise, in order to infer secular velocities at the stations with consistent uncertainties. We then locate the pole of rotation of the Indian plate in the ITRF 2005 reference frame at longitude = − 1.34° ± 3.31°, latitude = 51.4° ± 0.3° with an angular velocity of Ω = 0.5029 ± 0.0072°/Myr. The pattern of coupling on the MHT is computed on a fault dipping 10° to the north and whose strike roughly follows the arcuate shape of the Himalaya. The model indicates that the MHT is locked from the surface to a distance of approximately 100 km down dip, corresponding to a depth of 15 to 20 km. In map view, the transition zone between the locked portion of the MHT and the portion which is creeping at the long term slip rate seems to be at the most a few tens of kilometers wide and coincides with the belt of midcrustal microseismicity underneath the Himalaya. According to a previous study based on thermokinematic modeling of thermochronological and thermobarometric data, this transition seems to happen in a zone where the temperature reaches 350°C. The convergence between India and South Tibet proceeds at a rate of 17.8 ± 0.5 mm/yr in central and eastern Nepal and 20.5 ± 1 mm/yr in western Nepal. The moment deficit due to locking of the MHT in the interseismic period accrues at a rate of 6.6 ± 0.4 × 1019Nm/yr on the MHT underneath Nepal. For comparison, the moment released by the seismicity over the past 500 years, including 14MW≥ 7 earthquakes with moment magnitudes up to 8.5, amounts to only 0.9 × 1019Nm/yr, indicating a large deficit of seismic slip over that period or very infrequent large slow slip events. No large slow slip event has been observed however over the 20 years covered by geodetic measurements in the Nepal Himalaya. We discuss the magnitude and return period of M > 8 earthquakes required to balance the long term slip budget on the MHT.

1 October 1989 in Geophysical Journal International
Verified
Journal Article
Open access
PDF file
PMPeter Molnar
Peter Molnar
HLHélène Lyon-Caent
Hélène Lyon-Caent
Summary. Fault plane solutions of earthquakes within and on the margins of the Tibetan Plateau show diverse styles of faulting and deformation, with thrust fau

17 June 2011 in Science
Verified
Journal Article
Closed access
PDF file
CVC. Vigny
C. Vigny
ASA. Socquet
A. Socquet
SPS. Peyrat
S. Peyrat
JRJ.-C. Ruegg
J.-C. Ruegg
MMM. Métois
M. Métois
EKE. Kendrick
E. Kendrick
Large earthquakes produce crustal deformation that can be quantified by geodetic measurements, allowing for the determination of the slip distribution on the fault. We used data from Global Positioning System (GPS) networks in Central Chile to infer the static deformation and the kinematics of the 2010 moment magnitude (Mw) 8.8 Maule megathrust earthquake. From elastic modeling, we found a total rupture length of ~500 kilometers where slip (up to 15 meters) concentrated on two main asperities situated on both sides of the epicenter. We found that rupture reached shallow depths, probably extending up to the trench. Resolvable afterslip occurred in regions of low coseismic slip. The low-frequency hypocenter is relocated 40 kilometers southwest of initial estimates. Rupture propagated bilaterally at about 3.1 kilometers per second, with possible but not fully resolved velocity variations.

1 January 1988
Verified
Book Chapter
Closed access
PMPeter Molnar
Peter Molnar
HLHélène Lyon-Caen
Hélène Lyon-Caen
JCJr. Sydney P. Clark
Jr. Sydney P. Clark
BBB. Clark Burchfiel
B. Clark Burchfiel
JSJohn Suppe
John Suppe
We review separately aspects of two types of forces that resist mountain building and therefore that affect the support, deep structure, and evolution of mountain ranges, using observations from the large-scale tectonics of Asia and the Andes to illustrate them. The first such force might be termed mechanical strength. In its simplest description, the lithosphère is flexed as an elastic plate under the weight of a mountain range thrust on top of the lithosphère. The gross shapes of foredeep basins and gravity anomalies over them show that the simple analyses, in terms of elastic plates over inviscid fluids, are reasonable first approximations. At the same time, the weights of some mountain ranges are inadequate to depress lithospheric plates to the depths of neighboring foredeep basins, and the weights of others would create deeper foredeep basins than observed if additional forces were not present. Thus, the strength of the lithosphère alone does not support all ranges. The strength of the lithosphère, however, does affect the geometry of major, deeply rooted thrust faults, which seem to behave as crustal-scale ramp-overthrust faults. Seismic activity seems to be concentrated on the steeper, deeper sections, whereas slip on the flatter planes parallel to the underthrusting basement seems to occur aseismically. The second force that resists mountain building is gravity; the forces that drive two plates together and that cause crustal thickening must do work against gravity. More gravitational potential energy is stored in a column of mass that includes a high range and thick crustal root than is in a column that is in isostatic equilibrium with the mountain belt but with thinner crust. Because of the increasing amount of work that must be done against gravity acting on an increasingly higher range, the range should reach a maximum mean elevation related to the force at which the plates are pushed together. In this sense, the mean elevations of high plateaus serve as crude pressure gauges for the average compressive stresses pushing on the margins of the plateaus. When the maximum elevations are reached, crustal shortening need not cease; convergence can continue as the range builds outward, growing laterally into a high plateau. Moreover, changes, possibly small ones, in the driving forces can lead to situations in which the crests of high ranges or high plateaus can undergo crustal extension while crustal shortening continues on the flanks of the range. From the simple analogy with the pressure gauge, we can use the simultaneous occurrence of crustal extension at high altitudes with crustal shortening on the flanks of the range to place crude limits on the average strength of the lithosphère at mountain ranges. Finally, we discuss aspects of the tectonic evolution of western North America that appear to be analogous with aspects of the active tectonics of the Himalaya, the Tibetan plateau, and the Tien Shan in Asia and the Andes.

1 October 1985 in Tectonics
Verified
Journal Article
Closed access
PDF file
LCLyon‐ Caen
Lyon‐ Caen
HÉHélène
Hélène
PMPeter Molnar
Peter Molnar

10 October 1983 in Journal of Geophysical Research
Verified
Journal Article
Open access
PDF file
HLHélène Lyon‐Caen
Hélène Lyon‐Caen
PMPeter Molnar
Peter Molnar
The intracontinental subduction of India beneath the Himalaya presents several similarities to that occurring at island arcs. We study one of those similarities by analyzing gravity anomalies across the Himalaya assuming that the topography is supported by the Indian elastic plate, flexed under the weight of both the overthrust mountains and the sediments in the Ganga Basin. We first examine in detail the effects of each of the following parameters on the configuration of the elastic plate and on the gravity anomalies: the flexural rigidity, the position of the northern end of the elastic plate (the amount of underthrusting of such a plate beneath the range), and the density contrasts between the crust and mantle and between the sediments and the crust. A plate with a constant flexural rigidity of about 0.7×1025N m (between 0.2 and 2.0×1025N m) allows a good fit to the data from the Lesser Himalaya and the Ganga Basin. Such a plate, however, cannot underthrust the entire Himalaya. Instead, the gravity anomalies show that the Moho steepens from only about 3° beneath the Lesser Himalaya to about 15° beneath the Greater Himalaya. This implies a smaller flexural rigidity beneath the Greater Himalaya (0.1 to 1.0×1023N m) than beneath the Ganga Basin and the Lesser Himalaya. Even with a thin, weak plate beneath the Greater Himalaya, the weight of the mountains depresses the plate too much unless an additional force or moment is applied to the plate. The application of a bending moment/unit length to the end of the plate of about 0.6×1018N m is adequate to elevate the Indian plate and to bring the calculated gravity anomalies in agreement with those observed. Both, the smaller flexural rigidity and the bending moment can be understood if we assume that part or all of the Indian crust has been detached from the lower lithosphere that underthrusts the Greater Himalaya. We study the tectonic implications of these results by means of a series of idealized balanced cross sections, from the collision to the present, that reproduce several important features of the geology of the Himalaya and predict an amount of eroded material comparable to that in the Ganga Basin and the Bay of Bengal. These cross sections include high‐grade metamorphic rocks near the Main Central Thrust and a steeper dip of it there than in the Lesser Himalaya. They predict rapid uplift only in the Greater Himalaya and at the foot of the Lesser Himalaya.