10 February 2020 in IEEE Access
Conventional single-cell dual buck inverters present high reliability, however they cannot be directly used in high voltage applications, because of the limited voltage rating of commercial switching devices. Therefore, a novel modular multilevel dual buck inverter (MMDBI), capable of processing voltage and power at higher levels, requiring a single dc input voltage, is proposed in this paper. Non-interleaved phase-shifted discontinuous modulation (NIPSDM) and interleaved phase-shifted discontinuous modulation (IPSDM) schemes are applied to the proposed inverter to reduce the current stress in the switching devices. Despite beneficial to the converter efficiency, the use of these discontinuous modulation approaches results in current zero-crossing distortion, which needs to be appropriately managed. In this work, theoretical values for the common-mode and differential-mode current ripples under NIPSDM and IPSDM modulation strategies are derived, and each switching operating mode is fully analyzed. From that, an adjustable current threshold value, which depends on the theoretical current ripple magnitude, is incorporated into the modulation strategy, producing a minimum switching overlap period between the two buck cells that eliminates the current zero-crossing distortion and produces a high-quality output current. Extensive simulation and experimental investigations are presented to demonstrate the feasibility and effectiveness of proposed topology and adjustable discontinuous modulation strategy.
6 October 2020 in IEEE Access
The modular multilevel DC transformer (MMDCT) is more likely to suffer from transient oscillation, which is caused by insufficient damping of the equivalent RLC circuit with smaller arm resistance and submodule capacitance and may threaten the system stability. To tackle this issue, this paper conducts an in-depth analysis of the oscillation generating mechanism and thereby proposes a transient oscillation suppression method by incorporating an oscillation suppression angle (OSA) between the upper and lower arm switching voltages, with which the direction of the circulating current could be adjusted during this overlapped period. However, the open loop control of OSA shows indistinctive improvement of the damping ratio so that a damping compensator for regulating the circulating current is utilized. Furthermore, the compensating gain is optimally designed to achieve the critical damping state based on the small-signal model viewing OSA as an input variable. Besides, the outer capacitor voltage control loop and the power control loop are incorporated to provide the circulating current reference and to track the load power demand, respectively. Extensive simulation results from a realistically designed MMDCT model in PSIM validate the feasibility and effectiveness of the proposed transient oscillation suppression method.