2 June 2025 in Chemical Science
Pyridine N-oxide ylide COF, modified with electron-withdrawing and π-conjugated groups, spontaneously converts to a stable biradical COF, enabling efficient N-heterocycle dehydrogenation.
1 January 2023 in e-Polymers
This article proposes the preparation and microwave thermal cured (MTC) epoxy-modified phenolic fibers for the first time. Epoxy-modified thermoplastic phenolic resin was first prepared in acidic condition using phenol, formaldehyde, and epichlorohydrin as the reactants, and then underwent additive reaction with formaldehyde to obtain epoxy-modified thermosetting phenolic resin, which was converted into nascent fibers through wet spinning. Finally, epoxy-modified phenolic fibers were obtained through different curing methods including solution cured, solution thermal cured, microwave cured, MTC, and was characterized by infrared spectroscopy, microscopic infrared imaging, nuclear magnetic resonance, thermogravimetric analysis, and scanning electron microscopy. The experiment results show that MTC epoxy-modified phenolic fibers have optimal mechanical property with ultimate elongation of 4% and breaking strength of 133 MPa.
1 April 2024 in Journal of Superhard Materials
A TiC coating was rapidly formed on the surface of diamond particles by thermal explosion reaction using Ti/Carbon black/PTFE/Diamond powders as raw materi
9 October 2025 in Journal of Materials Science
1 December 2023 in Polymer Science, Series B
Phenolic fibers are a new type of heat-resistant organic fiber material prepared through spinning. They are made of phenolic resin and are spun and cured to obtain corrosion-resistant, high-temperature heat-insulating, smokeless, nontoxic fibers. Pure phenolic fibers have limitations in some applications due to their poor toughness and brittleness. Therefore, the improvement of the toughness of phenolic fibers and spinning has become the focus of research. In this work, phenolic fibers with an elongation at break of 8.7% and a breaking strength of 162.5 MPa were obtained by spinning epoxy-toughened phenolic resin. First, a high-ortho thermosetting phenolic resin solution (TPRS) was synthesized and blended with the phenolic epoxy resin F-44. Subsequently, as-spun fibers were prepared through dry-spinning. Finally, the as-spun fibers were subjected to microwave curing (MC). The effects of different TPRS : F-44 ratios and MC durations on the mechanical properties of the fibers were systematically investigated. Experimental results showed that under microwave conditions at a curing power of 80 W, the optimal mass ratio of TPRS : phenolic epoxy resin was 50 : 12 and the optimal curing time was 8 min. After the curing reaction, a large amount of hydroxymethyl groups was generated. During curing, the hydroxymethyl groups generated additional methylene bridges and epoxy groups underwent ring-opening reactions. Finally, a reticulated polymer was generated.
15 March 2024 in Journal of Elastomers & Plastics
The increasing advancements in science and technology have led to a growing demand for wearable products. In this paper, copper sulfide/melamine foam composites were prepared by chemical deposition of copper sulfide on the melamine foam skeleton. The effects of different deposition amount of copper sulfide on its microstructure, and electrical conductivity were studied. The results showed that the composite had good electrical conductivity and flexibility when the reaction solution concentration was 1 wt.%. The material can be used as an electric heater, the surface of the material can be heated to 145°C under the low voltage of 4 V, and the material can also be used as a flexible pressure sensor with a high sensitivity of 0.385 kPa−1 and a stability of more than 2000 cycles. Materials based on flexible copper sulfide/melamine foams can be used for electric heaters and flexible pressure sensor, which will make them promising applications in wearable products.