Concave microlens arrays fabricated over typical quartz or silicon wafer demonstrate an important ability of uniformly diverging incident beams in the visible or infrared wavelength range, which are already utilized in many applications such as optical scanners,1 diffusers,2 digital display units,3 biomedical instrumentation,4 optical communications,5 and other microelectro-mechanical systems (MEMS).6,7 Silicon concave microlens has been successfully used as a mold for a continuously electroplating metal mold or directly replicating plastic microlens.8,9 As shown, many fabrication methods have been developed for effectively shaping concave microlens with the required appearance according to a refract or reflect lightwave strategy, for example, common ultraviolet (UV)-photolithography combining melting, wet potassium hydroxide (KOH) etching,10 ion beam etching,11 – 13 impressing or embossing,14,15 microdroplet jetting,16 ultraprecise machining process such as typical diamond cutting or grinding,17,18 three-dimensional (3D) printing or imprinting,19 – 22 thermal reflowing,23,24 laser,25 – 27 electron beam direct writing or electrochemical method,28 and so on. Generally, the methods mentioned above all present some intrinsic disadvantages. Common UV-photolithography and laser direct writing are unsuitable for fabricating microstructures with a complex contour or relief appearance based on finely defining exposure doses. The low-cost impressing or embossing manipulation highly relies on the interface coupling properties between the processed materials and the patterned mold with a featured nanometer size. With current microdroplet jetting, it is usually hard to control the consistency and microstructural size of each pixel micro-nano-domain shaped by overlapping jetting droplets for the fitting surface profile leading to the designed appearance of microlens.29 As demonstrated, many refractive or diffractive microlens can be acquired by ultraprecise machining, which presents a tedious and expensive feature that creates a bottleneck for fabricating microdevices with relatively large sizes. At present, large-scale lens arrays can be fabricated by laser direct writing technology based on gray exposure and high-speed 3D printing technology. The imprinted profile of the microstructures cannot be completely the same as that of the mold because of the residual surface stress or microstructural mismatching between the mold and the optical materials processed. The contact angle between the arc boundary of a single microlens and the connected facets of the substrate is only determined by the wettability of the thermal reflow material over the substrate used and their surface tension, so it is very difficult to shape microstructure with a required or even arbitrary profile using nano-imprint technology.29 The expensive electron beam direct writing is obviously not suitable for mass production of microlens.