20 May 2023 in International Journal of Impact Engineering
1 May 2025 in Defence Technology
16 April 2025 in Thin-Walled Structures
12 May 2026 in SSRN Electronic Journal
This study was conducted to enhance the mechanical properties and stability of ultra-high-performance concrete (UHPC) under both ambient and high temperatures. The objective was to meet the demands of increasingly complex civil facilities and protective engineering under coupled extreme loads. To this end, compressive tests were conducted on steel fiber ultra-high-performance concrete (SFRUHPC) incorporating 1 vol%, 2 vol%, and 3 vol% steel fibers (SF) across ten temperature levels ranging from 28℃ to 800℃. The findings demonstrated that at 250℃, the compressive strengths of the three UHPCs declined by 10.73%, 18.07%, and 20.56%, respectively, and all exhibited violent spalling after 300℃. In order to enhance the high-temperature strength stability of UHPC, polypropylene (PP) fibers were incorporated with the objective of mitigating internal vapor pressure. The experiment systematically investigated the strength evolution, deformation characteristics, and thermal stability of hybrid fiber-reinforced UHPC containing 0.1 vol%, 0.2 vol%, and 0.3 vol% PP fibers at different temperatures. The findings indicated that within the hybrid fiber UHPC system, SF exhibited a predominant role in strength enhancement, where an increased volume fraction effectively impeded crack propagation and augmented compressive strength. PPs were found to play a pivotal role in enhancing thermal stability. A low volume fraction was observed to result in a substantial alleviation of high-temperature spalling, while an excessive volume fraction led to a reduction in both the elastic modulus and compressive strength of the material at high temperatures. The UHPCs incorporating 3 vol% SF and 0.1 vol% PP fibers exhibit the best performance.
25 July 2026 in SSRN Electronic Journal
To meet the service requirements of civilian infrastructure and protective structures under extreme coupled loading, this study conducted a systematic experimental investigation and mechanistic analysis. The aim was to improve the mechanical properties of ultra-high-performance concrete (UHPC) at both ambient and elevated temperatures. UHPC specimens containing 1-3 vol% steel fibers (SF) were tested from 28 °C to 800 °C. Explosive spalling occurred in all specimens after exposure to 300 °C. To enhance thermal stability, 1-3 vol% polypropylene (PP) fibers were added to relieve internal steam pressure. The evolution of strength, deformation characteristics, and thermal stability of the resulting hybrid fiber-reinforced UHPC was systematically investigated under varying test temperatures. Results show that SF plays a dominant role in strength enhancement. PP fibers contribute critically to thermal stability improvement. The optimal SF3PP0.1 specimen exhibited a residual strength ratio of 95% after 2 hours of sustained exposure at 400 °C. Nonlinear regression analysis reveals that the elastic modulus exhibits a sigmoidal decay with increasing temperature, while the peak strain grows exponentially. The PP content exerts a linear negative effect on the elastic modulus and a quadratic, parabolic positive effect on the peak strain. The critical temperature for the evolution of UHPC mechanical properties is 340 °C. Below this temperature, failure tends to occur in a brittle mode, whereas above it, UHPC tends to occur in a ductile mode. These findings provide a theoretical basis for the structural design of UHPC in high temperature environments.