1 October 2022 in International Journal of Electrical and Computer Engineering (IJECE)
Particle swarm optimization (PSO) is the most widely used soft computing algorithm in photovoltaic systems to address partial shading conditions (PSC). The success of the PSO run heavily depends on the initial population size (NP). A higher NP increases the probability of a global peak (GP) solution, but at the expense of a longer convergence time. To find the optimal value of NP, a trade-off is typically made between a high success rate and a reasonable convergence time. The most used trade-off method is a trial-and-error approach that lacks explicit guidelines and empirical evidence from detailed analysis, which can affect data reproducibility when different systems are used. Hence, this study proposes an empirical trade-off method based on the performance index (PI) indicator, which takes into account the weighted importance of success rate and convergence time. Furthermore, the impact of NP on achieving a successful PSO was empirically investigated, with the PSO tested with 16 different NPs ranging from 3 to 50, and 10,000 independent runs on various PSC problems. Overall, this study found that the best NP to use was 25, which had the best average PI value of 0.9373 for solving all PSC problems under consideration.
1 September 2016 in IET Power Electronics
SRSiti Rohani Sheikh Raihan
Siti Rohani Sheikh Raihan
Current source inverters (CSIs) have increasingly become popular because of their inherent advantages over voltage source inverter. In a single phase system, the operation of multilevel current source inverter (MCSI) requires large and bulky DC link inductor and the employment of switching state redundancy to balance the inductor currents limit the advantages of MCSI. This study proposed a new configuration for parallel MCSI. The proposed energy‐recovery scheme provides a major path to release its stored energy in order to balance the sharing inductor currents and introduces a novel single state switching technique for the generation of MCSI output current. In addition, a chopper circuit with smaller inductor size is employed to replace the large and bulky input DC link inductor. An integration of five‐level MCSI and a chopper based DC‐current source with energy recovery scheme circuits produce a five‐level MCSI with a simple converter structure. The performance of the proposed MCSI is analysed through MATLAB and is verified by constructing a prototype. The results demonstrate that the proposed circuit with the balancing inductor current scheme significantly reduces the input DC link inductor size, eliminate the control complexity in balancing the inductor currents and has excellent sharing inductor current characteristics.
16 August 2018 in IETE Journal of Research
In a power conditioning fuel cell system, the application of a single phase voltage source inverter (VSI) generates a second harmonic (100/120 Hz) ripple current. The harmonic current reduces life, efficiency and performance of the fuel cells due to hysteresis loss effects. This paper proposes current source inverter (CSI) with multilevel features to reduce the second harmonic (100/120 Hz) current ripple drawn from the Proton Exchange Membrane (PEM) fuel cell. The employment of energy recovery scheme in the proposed five-level multilevel current source inverter (MCSI) introduces a single switching state for each output current level. The proposed energy recovery scheme is able to balance the sharing inductor currents effectively. In addition, the proposed MCSI is also integrated with a boost DC current source in order to reduce the size of input DC link inductor and minimize the circuit structure for a reliable power conditioning PEM fuel cell system application.
1 September 2019 in International Journal of Power Electronics and Drive Systems (IJPEDS)
This paper presents the analysis study between multilevel inverters that are often classified into multilevel voltage source and multilevel current source inverters. For multilevel voltage source inverter (MVSI), the specific topology studied for this work is the Cascaded H-Bridge MVSI. Whereas, the multilevel current source inverter (MCSI) is based on Paralleled Inductor Configuration MCSI. For this study, the analysis between these converters are done with respect to the number of components, the advantages and disadvantages of each converters during performing inverter operation. In term of output voltage and current quality, the percentage of the Total Harmonic Distortion (THD) are measured and compared for both topologies. MATLAB/Simulink software has been used in this research to design and simulate in order to study the performances of both inverters.
1 June 2020 in Indonesian Journal of Electrical Engineering and Computer Science
The initialization stage12 of a Soft Computing (SC) algorithm is vital as it affects the success rate of algorithms in solving multi-peak global optimization problems. The individuals in an initial population, which are known as search agents, are often generated randomly using pseudo-random number generator (PRNG) due to unavailability of prior information on the location of global peak (GP). The random nature of the generated search agents causes uneven distribution of the initial population over the search space (SS), which may lead the search towards unpromising regions from the very beginning. This paper proposes a new deterministic initialization method (DIM) for SC algorithms where search agents are evenly fixed in the SS by using a simple deterministic formulation. The performance of the proposed DIM is then compared to the conventional PRNG and more recent quasi-random number generator (QRNG). An optimization case study is carried out using two popular SC algorithms which are the Particle Swarm Algorithm (PSO) and the Evolutionary Programming (EP), and three relatively new SC algorithms which are the Whale Optimization Algorithm (WOA), the Elephant Herding Optimization (EHO), and the Butterfly Optimization Algorithm (BOA). The optimization is done on various one-dimensional (1D) benchmark functions, as well as practical problems such as partial shading condition (PSC). Simulation results show that the proposed DIM successfully improved the performance of each SC algorithm under study in solving almost all tested functions with 99% success rate compared to 88.7% and 80.2% for the QRNG and PRNG approaches respectively. Furthermore, the WOA is the most reliable and robust among the five SC techniques under study with a success