Physical Science and Engineering Division (PSE), Computational Transport Phenomena Laboratory, King Abdullah University of Science and Technology (KAUST) 2 , Thuwal 23955-6900, Saudi Arabia
Auto-generated profile, based on publicly available information
Mohd Fuad Anwari Che Ruslan
Physical Science and Engineering Division (PSE), Computational Transport Phenomena Laboratory, King Abdullah University of Science and Technology (KAUST) 2 , Thuwal 23955-6900, Saudi Arabia
Molecular dynamics simulations were performed to study the bulk and interfacial properties of methane + n-decane, carbon dioxide + n-decane, and methane + carbon dioxide + n-decane systems under geological conditions. In addition, theoretical calculations using the predictive Peng-Robinson equation of state and density gradient theory are carried out to compare with the simulation data. A key finding is the preferential dissolution in the decane-rich phase and adsorption at the interface for carbon dioxide from the methane/carbon dioxide mixture. In general, both the gas solubility and the swelling factor increase with increasing pressure and decreasing temperature. Interestingly, the methane solubility and the swelling of the methane + n-decane system are not strongly influenced by temperature. Our results also show that the presence of methane increases the interfacial tension (IFT) of the carbon dioxide + n-decane system. Typically, the IFT of the studied systems decreases with increasing pressure and temperature. The relatively higher surface excess of the carbon dioxide + n-decane system results in a steeper decrease in its IFT as a function of pressure. Such systematic investigations may help to understand the behavior of the carbon dioxide-oil system in the presence of impurities such as methane for the design and operation of carbon capture and storage and enhanced oil recovery processes.
Molecular dynamics simulations were conducted to study the interfacial behavior of the CO2+H2O and hexane+CO2+H2O systems in the presence of hydrophilic silica at geological conditions. Simulation results for the CO2+H2O and hexane+CO2+H2O systems are in reasonable agreement with the theoretical predictions based on the density functional theory. In general, the interfacial tension (IFT) of the CO2+H2O system exponentially (linearly) decreased with increasing pressure (temperature). The IFTs of the hexane+CO2+H2O (two-phase) system decreased with increasing mole fraction of CO2 in the hexane/CO2-rich phase xCO2. Here the negative surface excesses of hexane lead to a general increase in the IFTs with increasing pressure. The effect of pressure on these IFTs decreased with increasing xCO2 due to the positive surface excesses of carbon dioxide. The simulated water contact angles of the CO2+H2O+silica system fall in the range from 43.8 to 76.0o, which is in reasonable agreement with the experimental results. These contact angles increased with pressure and decreased with temperature. Here the adhesion tensions are influenced by variations in fluid-fluid IFT and contact angle. The simulated water contact angles of the hexane+H2O+silica system fall in the range from 58.0 to 77.0o and are not much affected by the addition of CO2. These contact angles increased with pressure and the pressure effect was less pronounced at lower temperatures. Here the adhesion tensions are mostly influenced by variations in fluid-fluid IFTs. In all studied cases, CO2 molecules could penetrate into the interfacial region between the water droplet and the silica surface.
5 January 2025 in International Journal of Hydrogen Energy