The performance of direct-detection transceivers employing electronic dispersion compensation combined with DSP-based receiver linearization techniques is assessed through experiments on a 4 × 112 Gb/s wavelength-division multiplexing direct-detection single-sideband 16 quadratic-amplitude modulation Nyquist-subcarrier-modulation system operating at a net optical information spectral density of 2.8 b/s/Hz in transmission over standard single mode fiber links of up to 240 km. The experimental results indicate that systems with receiver-based dispersion compensation can achieve similar performance to those utilizing transmitter-based dispersion compensation, provided it is implemented together with an effective digital receiver linearization technique. The use of receiver-based compensation would simplify the operation of a fiber link since knowledge of the link dispersion is not required at the transmitter. The recently proposed Kramers-Kronig receiver scheme was found to be the best performing among the receiver linearization techniques assessed. To the best of our knowledge, this is the first experimental demonstration of the Kramers-Kronig scheme.
An experimental demonstration of direct-detection single-sideband Nyquist-pulse-shaped 16-QAM subcarrier modulated (Nyquist-SCM) transmission implementing a receiver-based signal-signal beat interference (SSBI) cancellation technique is described. The performance improvement with SSBI mitigation, which compensates for the nonlinear distortion caused by square-law detection, was quantified by simulations and experiments for a 7 × 25 Gb/s WDM Nyquist-SCM signal with a net optical information spectral density (ISD) of 2.0 (b/s)/Hz. A reduction of 3.6 dB in the back-to-back required OSNR at the HD-FEC threshold was achieved. The resulting reductions in BER in single channel and WDM transmission over distances of up to 800 km of uncompensated standard single-mode fiber (SSMF) achieved are presented.
31 October 2016 in IEEE Photonics Technology Letters
A novel digital two-stage linearization filter is proposed for direct-detection (DD) systems and assessed experimentally for the first time. The performance improvement is quantified by experiments with a $7\times25$ Gb/s wavelength division multiplexing DD single sideband 16-QAM Nyquist-shaped subcarrier modulation system with a net optical information spectral density of 2.3 (b/s)/Hz. The results indicate that this technique can effectively compensate the nonlinearity caused by square-law detection, while, at the same time reducing the DSP complexity, avoiding the need to perform the multiple iterations which are required in previously proposed beating interference cancellation methods.
27 December 2017 in Journal of Lightwave Technology
Due to their simple and cost-effective transceiver architecture, single-polarization and single-photodiode-based direct-detection (DD) systems offer advantages for metropolitan area network and data-center interconnect applications. Single-sideband subcarrier modulation (SSB SCM) signaling with DD has the potential to achieve high information spectral density (ISD) but its performance can be significantly degraded by signal-signal beat interference (SSBI). The recently proposed Kramers-Kronig (KK) digital signal processing scheme is effective in eliminating the SSBI penalty. Through the use of the KK scheme, we achieved 4 × 168 Gb/s wavelength division multiplexing DD SSB 64-QAM Nyquist-SCM signal transmission over 80 km of uncompensated standard single-mode fiber at a net ISD of up to 4.61 (b/s)/Hz. The joint optimization of the optical carrier-to-signal power ratio and the KK algorithm sampling rate is described.
Single-polarization direct-detection transceivers may offer advantages compared to digital coherent technology for some metro, back-haul, access and inter-data center applications since they offer low-cost and complexity solutions. However, a direct-detection receiver introduces nonlinearity upon photo detection, since it is a square-law device, which results in signal distortion due to signal-signal beat interference (SSBI). Consequently, it is desirable to develop effective and low-cost SSBI compensation techniques to improve the performance of such transceivers. In this paper, we compare the performance of a number of recently proposed digital signal processing-based SSBI compensation schemes, including the use of single- and two-stage linearization filters, an iterative linearization filter and a SSBI estimation and cancellation technique. Their performance is assessed experimentally using a 7 × 25 Gb/s wavelength division multiplexed (WDM) single-sideband 16-QAM Nyquist-subcarrier modulation system operating at a net information spectral density of 2.3 (b/s)/Hz.
27 November 2017 in Journal of Lightwave Technology
Single-polarization, single-photodiode based direct-detection (DD) transceivers offer advantages for metro networks due to their simple and low-cost optical hardware structure. Single-sideband Nyquist-pulse-shaped subcarrier modulation (SSB Nyquist-SCM) is a promising signal format to achieve high information spectral density (ISD) in such DD systems. In this paper, we present theoretical and experimental evaluations of a variety of direct-detection SSB Nyquist-SCM system designs, operating at 100 Gb/s per wavelength in WDM metro network scenarios. Through simulations, several receiver-based digital linearization techniques to overcome the effect of signal-signal beat interference were investigated, and their performance compared with alternative approaches, including optical beat-interference cancellation receivers (BICRx) and coherent receivers (both heterodyne and homodyne). Subsequently, experimental assessments of the digitally-linearized DD receivers were carried out. Spectrally-efficient (net ISD exceeding 3 (b/s)/Hz) 4 × 112 Gb/s WDM DD single-sideband 16-QAM Nyquist-SCM transmission over distances of up to 240 km (multi-span links) and 160 km (single-span links without inline amplification) were shown to be possible using uncompensated standard single mode fiber.