24 July 2017 in RSC Advances
Na-ion batteries offer an attractive low-cost alternative to Li-ion batteries. Although graphite is used as the negative electrode in conventional Li-ion batteries, attempts to use it in Na-ion batteries have been hampered by the inability of Na to form graphite intercalation compounds (GICs) under moderate conditions. It is generally considered that this is due to the size mismatch between Na and the graphite interlayer spacings, but here we show with detailed first-principles calculations of Li, Na, K, Rb, and Cs GICs that the major reason is the change in chemical bonding between alkali metal (AM) ion and C atoms. van der Waals correction terms are introduced to better reproduce the layered graphite structure, and calculated formation energies of GICs AMC6, where AM = Li, Na, K, Rb, and Cs, are found to become less negative (less stable) as ion size decreases from Cs to Na as a result of weakening ionic bonding, until the formation energy of NaC6 becomes positive. The much smaller Li ion represents an exception to this trend, as its bonds with C atoms contain a covalent component, resulting in a negative formation energy. These subtle differences in staging for the different alkali metals explain why graphite is a good intercalation material for Li and K but not for Na.
2 November 2012 in Advanced Materials
16 June 2014 in Applied Physics Letters
The possibility of the new class ferroelectric materials of wurtzite structure simple chalcogenide was discussed using modern first-principles calculation technique. Ferroelectricity in the wurtzite structure (P63mc) can be understood by structure distortion from centrosymmetric P63/mmc by relative displacement of cation against anion along c-axis. Calculated potential surface of these compounds shows typical double well between two polar variants. The potential barriers for the ferroelectric polarization switching were estimated to be 0.25 eV/f.u. for ZnO. It is slightly higher energy to the common perovskite ferroelectric compound PbTiO3. Epitaxial tensile strain on the ab-plane (0001) is effective to lower the potential barrier. The potential barrier decreased from 0.25 to 0.15 eV/f.u. by 5% ab-plane expansion in wurtzite structure ZnO. Epitaxial ZnO thin film with donor type defect reduction should be a possible candidate to confirm this ferroelectricity in wurtzite structure simple chalcogenide.
30 November 2018 in Journal of Materials Chemistry A
Atomic-resolution STEM and EELS analysis provide insights into microscopic mechanisms behind oxygen loss and capacity fade in spinel-structured lithium-ion battery cathode material LiMn 2 O 4 .
26 January 2017 in Physical Review B
Using first-principles calculations we examine the crystal structures and phase transitions of nitride perovskite . Lattice dynamics calculations indicate that the ground-state structure belongs to space group . Two competitive phase transition pathways are identified which are characterized by symmetry-adapted distortion modes. The results suggest that should be an excellent ferroelectric semiconductor, as its large spontaneous polarization of around 61 is comparable to that of , and its band gap is about 1.72 eV. Ferroelectricity is found to result from the -site instability driven by hybridization between and orbitals. These properties make an attractive candidate material for use in ferroelectric memory devices and photovoltaic cells.
9 September 2011 in Physical Review B
First-principles calculations of various phases of CdTiO carried out with the aim of obtaining insights into the mechanism of the ferroelectric phase transition and the structure of the low-temperature ferroelectric phase are reported. The results indicate that the preferred symmetry of the low-temperature phase is Pna2, rather than 2, corresponding to a small relative shift of the Ti and O ions in the paraelectric Pnma phase with the polarization axis parallel to the long axis. Calculated phonon dispersion curves show a distinct soft mode at the Γ point of the Pnma phase, which vanishes in the Pna2 phase, confirming that the transition to the ferroelectric phase is of the soft-mode displacive type. Calculations of perovskite CaTiO, which also has an orthorhombic Pnma structure at room temperature but, unlike CdTiO, does not exhibit a ferroelectric phase transition down to 4.2 K, were also carried out to help characterize the factors controlling ferroelectric phase transitions in perovskite titanates.