3 June 2024 in Applied Physics Letters
Diamond Schottky barrier diodes (SBDs) could theoretically operate at high voltage, high temperature, and high frequency and be potentially used in power electronics. However, the device breaks down prematurely and cannot operate stably at high voltages due to the edge electric field crowding. In this work, a vertical diamond SBD with a curved field plate (CFP) was prepared using a chemical reflow method, inductively coupled plasma etching, and electron-beam evaporation. This structure alleviates the electric field crowding at the edge of the Schottky electrode and results in a breakdown voltage and current density of 380 V and over 3000 A/cm2, respectively. After repetitive measurements, we found that the device can repeatedly breakdown at around 380 V. These results indicate that CFP structure diamond SBDs have great application in high-voltage and high-power electronic devices.
27 November 2024 in IEEE Transactions on Electron Devices
A normally-off high-performance hydrogenated diamond (H-diamond) field-effect transistor (FET) has been fabricated and investigated. The deep X-ray photoelectron spectroscopy (XPS) analysis reveals the Gd $_{\text{2}}$ O $_{\text{3}}$ /Gd double layer gate structure. The threshold voltage ( $\textit{V}_{\text{TH}}$ ) is up to $-$ 1.4 V with 6- $\mu$ m gate length, which demonstrates the normally-off operation caused by the low work function of Gd and the fixed positive charge of Gd $_{\text{2}}$ O $_{\text{3}}$ layer. The gate leakage current density J is as low as 5.8 $\times$ 10 $^{-\text{6}}$ A/cm $^{\text{2}}$ and ON/OFF ratio is as high as 10 $^{\text{10}}$ , which both can be due to the suppression by Gd $_{\text{2}}$ O $_{\text{3}}$ layer. The maximum drain current density, transconductance, OFF-state drain leakage current, subthreshold swing, maximum gate oxide capacitance, and effective mobility with 6- $\mu$ m gate length are $-$ 100 mA/mm, 18.9 mS/mm, 10 $^{-\text{8}}$ mA/mm, 121 mV/dec, 0.24 $\mu$ F/cm $^{\text{2}}$ , and 417.7 cm $^{\text{2}}$ /V $\cdot$ s, respectively. The trapped charge density, fixed charge density, and interface state density are 4.87 $\times$ 10 $^{\text{11}}$ cm $^{-\text{2}}$ , 3.57 $\times$ 10 $^{\text{12}}$ cm $^{-\text{2}}$ , and 1.52 $\times$ 10 $^{\text{12}}$ cm $^{-\text{2}}\cdot$ eV $^{-\text{1}}$ , respectively. This work demonstrates a simple fabrication approach to achieve normally-off FET with large $\textit{V}_{\text{TH}}$ and low leakage current, which contributes to the advancement of diamond for circuit applications.
23 August 2024 in IEEE Electron Device Letters
The directly coupled hydrogen-terminated diamond FET logic (DCHDFL) circuit is fabricated. The E-mode and D-mode FETs are assigned as driver and load devices of the DCHDFL circuit to achieve inversion characteristics. The E-mode FET showcases high I DSmax of 53.3mA/mm, V TH of -0.8 V, low SS of 98 mV/dec and on/off ratio of 109, which enable input/output logic level matching with a low drive/load ratio of 1.0. The peak gain of circuit increases from 12.57 to 36.3 V/V with VDD ranging from -5 V to -25 V, which is the highest gain achieved of diamond inverters, due to the high on/off ratio and low SS of E-mode FET. This circuit exhibits proper functions up to 200 °C, demonstrating a good thermal stability. These results indicate the great potential and possibilities for diamond smart power integrated circuit application.
31 March 2025 in Applied Physics Letters
Enhancement-mode hydrogen-terminated diamond (C-H diamond) field effect transistors (FETs) are strongly desirable for safety protection, energy saving, etc., and low work function gate material is an effective and convenient way to deplete the two-dimensional hole gas and realize the enhancement-mode. In this article, we demonstrate a C-H diamond FET with low work function gadolinia (Gd2O3) gate materials. For the 4 μm gate length (LG) Gd2O3 C-H diamond FET, the device demonstrates an obvious enhancement-mode with a threshold voltage of −1.3 V. Besides, the maximum source/drain current density and the leakage current density are −80.0 mA/mm and 1.6 × 10−6 A/cm2 at a gate voltage of −7 V, respectively. Moreover, the device demonstrates a saturation carrier mobility of 437.3 cm2/V · s. Accordingly, this enhancement-mode C-H diamond Gd2O3 FET demonstrates high performance with relatively high source/drain current density and low leakage current density, which will provide a strategy for the development of enhancement-mode C-H diamond FETs significantly.
23 December 2024 in Applied Physics Letters
A normally-off field effect transistor with 15 nm LaB6 gate material directly deposited on hydrogen-terminated diamond surface has been fabricated and characterized. The reason for the normally-off operation could be attributed to the low work function of LaB6 layer, which can deplete holes in the channel. Due to the formation of C–B bond of interface and the thin thickness of LaB6, the subthreshold swing is as low as 70.6 mV/dec and interface state density is as low as 2 × 1011 cm−2eV−1. The maximum drain current density (IDSmax), extrinsic transconductance (Gm), threshold voltage (VTH), and on/off ratio for the device with 8-μm gate length are −60 mA/mm, 5 mS/mm, −1.1 V, and 109, respectively. The low-field mobility (μ0) without vertical-field degradation is 187 cm2/V s. The trapped charge density and fixed charge density are 8.75 × 1011 and 1.26 × 1012 cm−2, respectively. The LaB6/H-diamond logic inverters coupling with different load resistors show distinct inversion characteristics with a peak gain of 4.7 V/V.
28 April 2025 in IEEE Transactions on Electron Devices
Logic circuits are the first step toward integrated circuits. Here, we fabricated the monolithically E/R logic, direct coupled E/E logic, and E/D inverter logic circuit with respective loads of resistor, enhancement field-effect transistor (FET), and depletion FET using hydrogenated diamond and observed the performance of these logic circuits. The gain and voltage swing of E/R logic circuits are strongly influenced by the value of the load resistance, which are commonly employed in separate components. E/E logic circuit exhibits small voltage swing, low gain, and low noise margin. E/D logic circuits present significant advantages in terms of voltage swing, gain, noise margins, and power consumption over E/R and E/E logic circuits. The E/D mode circuit shows a logic voltage swing of -9.44 V, a voltage gain of 15.5 V/V, low-/high-noise margins of 0.82/7.07 V, and static power consumption of 10-3 W and proper functions up to at least 200 ∘C at a supply voltage of -10 V. These results show great potential for diamond smart power integrated circuit application.