Fatty alcohols (FOH) are industrially obtained by heterogeneous catalytic hydrogenolysis of fatty acid methyl esters (FAME). Reaction rates are strongly dependent on hydrogen concentration at the catalyst surface, which is limited by the low solubility of hydrogen and high mass-transport resistance of the liquid substrate. The addition of a supercritical solvent can bring the reactive mixture into a single phase, increasing the reaction rate by several orders of magnitude. Propane has shown to be an adequate supercritical medium for these reactions. To find the homogeneous region and to determine the most favorable process conditions, it is a prerequisite to know the phase equilibrium boundaries of the reactive mixture as the reaction proceeds. This paper reports experimental phase equilibrium data on binary and ternary mixtures of propane with the reactants and reaction products of the hydrogenolysis of methyl palmitate: methyl palmitate, hydrogen, hexadecanol and methanol. A temperature region between 300 and 450 K, and pressures up to 15 MPa were covered. A liquid–liquid–vapor region was found in the system hexadecanol + hydrogen + propane, showing retrograde behavior of the lighter liquid phase.
Knowledge about the interfacial properties of water/oil mixtures is important for the petrochemical industry and for understanding detergency and hydrophobic effects. Here, we probe the liquid/vapour interface of water/n-hexane mixtures using configurational-bias Monte Carlo simulations in the osmotic Gibbs ensemble. We study the effect of n-hexane at several partial pressures ranging from 25% to 95% of its saturated vapour pressure and observe that the surface tension decreases with increasing n-hexane pressure. Additionally, we analyse the simulation trajectories to provide molecular-level insights on the spatial distribution of n-hexane and the structure of the interface. The n-hexane molecules strongly adsorb from the vapour phase onto the liquid interface with a preferentially parallel orientation with respect to the interface. The surface excess, from the Gibbs adsorption isotherm equation, is calculated and used to systematically define the domain of adsorbed n-hexane. Integrating over this gives the free energy of adsorption of n-hexane, which is highly favourable, varying from to kJ/mol as the partial pressure of n-hexane is increased. The enrichment of n-hexane molecules on the interface yields a positive deviation from Henry's law at higher partial pressures, providing evidence for favourable adsorbate-adsorbate interactions. GRAPHICAL ABSTRACT
In this work the Gibbs–Duhem integration method is used in combination with molecular simulation in the semigrand ensemble to simulate vapour–liquid equilibria for the binary mixtures ethane–methane and carbon dioxide–dimethylsulphoxide (DMSO). In both binary mixtures, the two components have a large difference in relative volatility. The starting point for tracing the vapour–liquid phase envelope is either calculated in a pure species NVT Gibbs ensemble simulation or in a pure species NpT+test particle simulation. The chosen method depends on the vapour pressure of the pure species. An equation is presented that relates the initial slope of the Clapeyron equation to an ensemble average in the Gibbs ensemble. The NpT+test particle method is slightly modified in order to improve the convergence characteristics when one of the coexisting phases is a (very) dense phase. Configurational-bias methods are used in the NVT Gibbs ensemble to enhance the acceptance of particle exchanges, and in the NpT+test particle method to grow test particles in a dense liquid phase. Force-biased molecular translations and torque-biased molecular rotations are used to enhance the diffusion of molecules in state space. The work shows the capability of the combination of the NpT+test particle method and Gibbs–Duhem integration to predict vapour–liquid equilibria of binary systems with components differing largely in volatility.