State Key Laboratory of Heavy Oil Processing, College of Chemistry and Chemical Engineering, China University of Petroleum (East China), Qingdao 266580, PR China
Auto-generated profile, based on publicly available information
Ning Yu
State Key Laboratory of Heavy Oil Processing, College of Chemistry and Chemical Engineering, China University of Petroleum (East China), Qingdao 266580, PR China
Due to the surface adsorption and interlayer insertion behavior of chloride anions, the Fe–Ni(oxy)hydroxide catalytic surface is easily destroyed, making it difficult to be used for long-term seawater electrolysis. Here, we developed a time- and labor-saving rapid surface reconstruction assisted by a directional anodic corrosion strategy to in situ construct a chrysanthemum shaped active catalytic layer of Fe–Ni(oxy)hydroxide used for seawater electrolysis on the surface of commercial self-supported metal materials. The purpose of the initial artificial anodic corrosion process is to directionally control the rapid corrosion of Fe on the surface of Fe–Ni foam to form a relatively stable Ni-rich structure, which can act as the host of Fe* (Fe* or Ni* represent surface active species of high-valence generated by the oxidation activation) redeposition to slow down the loss of active Fe*. Due to the special structure of the Fe–Ni(oxy)hydroxide catalytic layer tightly loaded on the surface of the Fe–Ni alloy, during the later stability test in natural seawater, the Cl− corrosion can accelerate the surface reconstruction of Fe–Ni(oxy)hydroxide to cause “rapid self-healing”, which is not only conducive to the regular renewal of the catalytic layer, but can prolong the stability of its resistance to seawater electrolysis. Eventually, the sample prepared by anodic corrosion and electrochemical reconstruction (named AC-FeNi(O)OH) only required 252 mV of low overpotential to provide a current density of 100 mA cm−2, and also tolerated over 100 hours in alkaline brine and natural seawater.
15 May 2020 in European Journal of Environmental and Civil Engineering
The mechanism of toppling deformation and failure is important in the stability analysis of anti-dip layered rock slopes, especially in a complex hydrogeological environment. In this paper, the flexural failure model is proposed for describing the mechanical behavior of toppling rock slope using the cantilever beam theory. A method for safety evaluation, considering the action of hydrodynamic force from groundwater, is developed. This model is then applied to conduct a case study of a toppling rock slope at a hydropower station on the Lancang River. The results show that the variation of reservoir water level increases both the tensile stresses and the deflections of rock slabs, which is manifested macroscopically by flexural displacements and failure. Based on the failure surfaces, the slope can be divided into three parts: toppling zone, creep zone, and shear zone. The failure mode of toppling rock slope is a combination of shear and toppling. Under the combined action of earthquake and rapid water drawdown, the toppling rock slope is at risk of shear instability at the leading edge; hence monitoring should be strengthened and prevention measures should be taken.
16 September 2020 in Applied Organometallic Chemistry