30 April 2019 in Journal of Geophysical Research: Solid Earth
In order to have a better understanding of the lithosphere formation and modification of the Tien Shan orogenic belt, we construct a well‐defined shear wave velocity model of the crust and upper mantle with full‐wave ambient noise tomographic method. High‐quality empirical Green's functions at periods of 7–200 s are extracted from the cross correlation of the vertical component of continuous seismic data at 108 stations during 2012–2014. Our tomographic results show remarkable velocity variations between and within the major tectonic units from the crust down to the upper mantle. We observe very slow upper crust beneath the Tarim and Junggar sedimentary basins. The interior of the Tarim Basin shows strong seismic heterogeneities. The high‐velocity mantle lithosphere of the Tarim Basin underthrusts northward toward the central Tien Shan. Lithosphere underthrusting could trigger intrusion of hot mantle material and partial melting, in correspondence with the prominent low‐velocity anomalies observed in the lower crust and uppermost mantle of the central Tien Shan. In contrast, the connected high‐velocity upper mantle structure from Tarim Basin across eastern Tien Shan to Junggar Basin may reflect the convergent effect between the Tarim and Junggar Basins, which consequently prevents the asthenosphere upwelling. We observe low‐velocity anomalies in the upper mantle of the western Tien Shan, indicating continental crust of the Eurasia lithosphere that has been subducted toward the western Tien Shan. The observed structural variations along the Tien Shan orogenic belt suggest different tectonic mechanisms for the lithosphere formation and modification of the three segments along strike.
29 September 2017 in Journal of Geophysical Research: Solid Earth
14 November 2018 in Seismological Research Letters
The goal of this study is to extract high‐frequency seismic waveforms recorded by both offshore and onshore instrumentations and to quantitatively evaluate the data quality in terms of source‐to‐receiver distance, source parameters, water depth, and sediment thickness. There were two active‐source seismic experiments within the Juan de Fuca plate, MGL1211 and MGL1212, during the first year deployment of the Cascadia Initiative Amphibious Array. In total, we chose 114 ocean‐bottom seismometers and 211 inland stations located around the experiment region. The common receiver gathering analysis shows that most offshore stations located in deep‐water record clear first P‐wave arrivals up to 150 km away from the air‐gun shot. The first arrival transits from crustal phase Pg to head wave Pn at a source‐to‐receiver distance of 25–40 km. For stations located at shallow water, the seismic recordings appear much noisier compared with those of deep‐water stations. Only five inland stations record clear air‐gun shot signals up to 200 km away from the source. The signal‐to‐noise ratio of the first P arrivals generally decreases from a few hundred down to a single number with increasing source‐to‐receiver distance, from deep () to shallow water (), with increasing sediment thickness and decreasing air‐gun shot spacing and time interval. On average, the ratio appears 5–10 times lower at inland stations than at offshore stations. The sediment thickness estimated in this study demonstrates significant along‐strike variations, which is up to 5 km offshore Oregon and 3.5 km offshore Washington. The coincidence of thick sediments with seismicity suggests the importance of sediments on the coupling of the plate interface.