The aim of this study is to examine the morphological properties of fibers produced by using metal plates of different thickness and materials as collectors in electrospinning. For this, circular shaped aluminum and copper plates of 1 mm, 5 mm, 10 mm thickness were used. The results show that much finer fibers were obtained when copper collectors are used compared to aluminum collectors. When the effect of collector thickness is analyzed, it was observed that fiber fineness increased as the collector thickness increased. In addition, it was observed that collection area of fibers on collector is much larger when aluminum collector and thinner collector is used showing that collector material and collector thickness affect fiber arrangement and interfiber spacing in electrospinning. A theoretical approach is also included in this work regarding effect of collector thickness and collector material type together with its verification in the light of experimental results.
30 December 2021 in European Journal of Engineering and Applied Sciences
In this study, we use the superposition principle to find a particular solution to Poisson and Laplace equations. It is assumed that the field in a homogeneous dielectric is excited by space charges under a specific density distribution. Under these assumptions, the results of visualization to electrostatic field solutions are reported for two cases: i) calculation of the electrostatic field between two shielded cables and ii) calculation of the electrostatic field between the dielectric corner and a parallel long charged conductor. In this study, we aim to initiate a discussion of the use of computer analysis and modeling as an educational tool for engineering students.
30 December 2021 in European Journal of Engineering and Applied Sciences
In this study, we derive some mathematical expressions that allow us to determine the proportion of charged aerosol particles in the corona, as well as analyzed the conditions of deposition of charged particles uniformly distributed in the space between the discharge and collecting electrodes. The numerical implementation of this method confirms its acceptable accuracy compared to known methods in the literature. The obtained results indicate that, under suitable conditions, use of a corona field can be an alternative technique for cleaning and refining impure aerosol mixtures for desired purposes.
30 August 2025 in Journal of Engineering Technology and Applied Sciences
Dielectric strength is a very important parameter for cables. It can vary according to temperature and frequency. The complex electrical permittivity of the Cross-linked polyethylene (XLPE) and Copper Polyester/Mylar band layers of a cable determine the maximum electric field created inside the cable operating at sinusoidal voltage. The value of this electric field should be less than the dielectric strength of the materials used. The electrical characteristics of XLPE and Copper Polyester tape depend on frequency and temperature. In a power cable, the temperature depends on the radial position, which makes it difficult to calculate the cable’s electric field. In this study, it was shown how to calculate the electric field of the cable by using XLPE and Copper Polyester band data taken from the literature and numerical integration. It was found that the calculated value is less than the Dielectric strength value of XLPE material. It has been shown how the electric field of the power cable under investigation changes according to frequency and temperature.
21 November 2023 in European Journal of Engineering and Applied Sciences
In this study, the solution of a variational problem that allows determining the input voltage form that provides the maximum power factor of the battery charging process in the RLC circuit and the change character of the charging current for constant R, L, C and charging time has been examined. The defined problem is obtained and solved in the form of a linear integro-differential equation. A quadratic voltage criterion is proposed to analyze the convergence of the power factor to its maximum value for various modes of charging the battery.