1 October 2013 in Solar Energy
1 October 2010 in Renewable Energy
1 May 2014 in Solar Energy
1 January 2012 in Energy Procedia
The objective of this paper is to propose a methodology for designing a stand-alone hybrid PV/wind/diesel/battery minimizing the Levelized Cost of Energy (LCE) and the CO2 emission using genetic algorithm. The methodology developed was applied using solar radiation, temperature and wind speed data, collected on the site of Gandon, located in the northwestern of Senegal. Obtained results were presented as optimal Pareto front. The optimal number of devices, the Levelized Cost of Energy (LCE) and the CO2 emission were determined for each solution. An influence study of the size of diesel generator on the optimal configuration was carried
1 January 2013 in Energy Procedia
This paper proposes a method for the detection and assessment of the degradation of the photovoltaic modules electrical characteristics such as short-circuit current (Isc), open-circuit voltage (Voc) and maximum output power (Pmax). This work presents a standardization method for measurements of these characteristics in real conditions. Standardization is bringing back the measurements in real conditions to the corresponding values in standard test conditions (STC). Thus the standardized values of short-circuit current (Isc,stc), the open-circuit voltage (Voc,stc) and the maximum output power (Pmax) are compared with reference values corresponding to the first putting service of module or the manufacturer's data as in our case. The data collected on a platform of measurements installed at the University of Dakar in Senegal are used to validate our approach. A Period of one operation year of the PV module is considered. After one year of module operation, we note an average degradation of 10% for the short-circuit current, 2% for the open-circuit voltage. For the maximum output-power no degradation is yet detected at this stage