CUPAC-NE (D3) collaboration is exploring construction of an AD-BNCT facility at Cotton University. Two accelerator configurations are considered: i) 4 MeV proton beam on 9Be target which was reported in our earlier study in 2025 using 9Be target and ii) 2.3 MeV proton beam on water cooled solid 7Li target which is currently implemented at Xiamen, China, Moscow, Russia and in Pavia, Italy. Because of the low proton energy, accelerator terminal voltage is below 1.2 MV and vacuum could be used as an insulator. However, for 4 MeV protons, the terminal voltage is >2 MV and requires SF6 gas as insulator which increases the cost and complexity of operation. The challenge is using high power beam on solid Li target. In this paper, design and simulation of 2.3 MeV proton beam incident on 7Li target and simulated results of reflector, collimator and thermal neutron filter is presented. Though the basic configuration is similar to Xiamen etc., we introduced a new feature of adding small layers of shell reflectors inside the moderators. These shell reflectors (Lead, Bismuth) result in scattering back of outward neutron flux towards the central region. This is expected to result in improvement in epithermal neutron flux. We noticed a slight improvement but more optimization work is required. This low energy Lithium based design with shell reflectors shows a dose rate at 2.5 cm depth are 0.11 Gy/min to healthy tissue and 0.64 Gy/min to cancerous tissue (3.5:1 of Boron concentration in tumor to blood ratio using BPA drug).
20 January 2026 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment