30 October 2019 in IEEE Transactions on Electron Devices
A compact L -band relativistic magnetron (RM) with the diffraction output (DO) of the TEM mode is proposed. In this DO configuration, a ridged circular waveguide is used to replace the cylindrical waveguide to decrease its radial dimension. The RF field of the operating π-mode is extracted from every resonator cavity and guided to the ridged circular waveguide. Even at the operating frequency of 1.55 GHz, the ridged circular waveguide can reduce the cutoff radius of the RF wave to 73 mm. The output RF field is further effectively converted to the TEM mode by a compact mode converter. Moreover, in the resonant system, a 10-cavity rising-sun slow wave structure (SWS) is applied to lower the phase velocity of the operating spatial harmonic and enhance the mode separation between the operating mode and the adjacent mode. The particle-in-cell (PIC) simulations demonstrate that the practical RM could output a relatively pure TEM mode at the frequency of 1.55 GHz, and its total efficiency is up to 60% with gigawatt radiation power for a diode voltage of 400 kV.
10 August 2020 in IEEE Transactions on Electron Devices
We propose a compact dual-frequency relativistic magnetron with TEM mode output. The resonant system consists of two axially separated beam-wave interaction regions for generating dual-frequency microwave. Under the same diode voltage and axial magnetic field, the RF field of the operating π -mode can almost be simultaneously established. Furthermore, the diffraction output and the all cavity axial extraction are integrated to realize the TEM mode output. Particle-in-cell simulation shows that when the diode voltage is 400 kV, microwaves with output powers of 740 and 876 MW generate, with frequencies of 2.05 and 2.35 GHz, respectively. With an axial magnetic field of 0.44 T, the device efficiency of over 43% in the dual-frequency relativistic magnetron is achieved.
8 July 2020 in IEEE Transactions on Microwave Theory and Techniques
To realize multiband mode conversion in the high-power microwave (HPM) application system, a novel compact dual-band mode converter based on a universal method is proposed in this article. The proposed converter has a hybrid circular-embedded coaxial structure, and it integrates the conventional plate-inserted coaxial TEM-TE₁₁ converter and serpentine circular TM₀₁-TE₁₁ converter simultaneously. Its outer and inner waveguides have the same curvature distributions along a longitudinal direction. Both the numerically calculated results and simulations exhibit that its maximum conversion efficiencies at two central frequencies are over 99% with a structure length of 240 mm. Simulated results indicate that the bandwidths reach 390 MHz (at X-band) and 4.2 GHz (at Ka-band), respectively, when the conversion efficiencies are over 95%. A prototype is fabricated and measured. The far-field results demonstrate that coaxial TE₁₁ and circular TE₁₁ modes with high purity are detected at the output port of converter, and the S-parameter measurements illustrate that high conversion efficiencies at 8.4 and 30.5 GHz are obtained. The measurement results have a good agreement with the theoretical predictions and simulations.
23 July 2019 in IEEE Transactions on Plasma Science
The characteristics of A6 relativistic magnetron with diffraction output (MDO) operating in the negative first harmonic of 2π /3-mode are studied in detail by theory analysis and particle-in-cell (PIC) simulation. By comparison with the fundamental harmonic of π -mode, it is found that the negative first harmonic of 2π /3-mode with lower phase velocity can be advantageous to improve the interaction efficiency, but its delay in the establishment is longer. Furthermore, the negative first harmonic of 2π /3-mode requires a larger axial magnetic field to satisfy the resonating condition under the same diode voltage. Therefore, the total power occupied by the MDO operating with the negative first harmonic of 2π /3-mode can be decreased in the same diode voltage condition. This can result in reduced RF power output. Employing a diode voltage of 400 kV in PIC simulation, the optimal magnetic field for the negative first harmonic of 2π /3-mode and the fundamental harmonic of π-mode are 0.51 and 0.39 T, respectively. The conversion efficiency at the negative first harmonic of 2π /3-mode is improved by 16.2%, whereas the input dc power is decreased by 1.22 GW, and the output RF power decreases 0.23 GW. Meanwhile, the oscillation delays about 3-4 ns.