In every tight formation reservoir, natural fractures play an important role for mass and energy transport and stress distribution. Enhanced Geothermal Systems (EGS) make no exception, and stimulation aims at increasing the reservoir permeability to enhance fluid circulation and heat transport. EGS development relies upon the complex task of predicting accurate hydraulic fracture propagation pathway by taking into account reservoir heterogeneities and natural or preexisting fractures. In this contribution, we employ the variational phase‐field method, which handles hydraulic fracture initiation, propagation, and interaction with natural fractures and is tested under varying conditions of rock mechanical properties and natural fractures distributions. We run bidimensional finite element simulations employing the open‐source software OpenGeoSys and apply the model to simulate realistic stimulation scenarios, each one built from field data and considering complex natural fracture geometries in the order of a thousand of fractures. Key mechanical properties are derived from laboratory measurements on samples obtained in the field. Simulations results confirm the fundamental role played by natural fractures in stimulation's predictions, which is essential for developing successful EGS projects.
The hydraulic performance and mechanical stability of open fractures are crucial for several subsurface applications including fractured geothermal reservoirs or nuclear waste repositories. Their hydraulic and mechanical properties (fluid flow and fracture stiffness) are both strongly dependent on the fracture geometry. Any change in effective stress impacts aperture and thus the ability of fractures to promote flow. Here, we carried out flow experiments with shear displaced tensile fractures in pre‐loaded, low‐permeability sandstones with two different cyclic loading scenarios with up to 60 MPa hydrostatic confining pressure. During “constant cyclic loading” (CCL) experiments, the fracture was repeatedly loaded to the same peak stress (up to 60 MPa). During “progressive cyclic loading” (PCL) experiments, the confining pressure was progressively increased in each cycle (up to 15, 30, 45, and 60 MPa). The matrix and fracture deformation was monitored using axial and circumferential LVDT extensometers to obtain the fracture stiffness. The fracture geometry before and after the experiment was compared by calculating the aperture distribution from 3D surface scans. Initial loading with confining pressure of the fracture leads to a linear fracture specific stiffness evolution. For any subsequent stress cycles fracture stiffness shifts to a nonlinear behavior. The transition is shown to be related to a stress memory effect, similar to the “Kaiser Effect” for acoustic emissions. Progressive loading of fractures possibly leads to less permeability reduction compared to continuous cyclic loading.