16 January 2017 in Journal of Orthopaedic Research
We created subject‐specific musculoskeletal models of the thoracolumbar spine by incorporating spine curvature and muscle morphology measurements from computed tomography (CT) scans to determine the degree to which vertebral compressive and shear loading estimates are sensitive to variations in trunk anatomy. We measured spine curvature and trunk muscle morphology using spine CT scans of 125 men, and then created four different thoracolumbar spine models for each person: (i) height and weight adjusted (Ht/Wt models); (ii) height, weight, and spine curvature adjusted (+C models); (iii) height, weight, and muscle morphology adjusted (+M models); and (iv) height, weight, spine curvature, and muscle morphology adjusted (+CM models). We determined vertebral compressive and shear loading at three regions of the spine (T8, T12, and L3) for four different activities. Vertebral compressive loads predicted by the subject‐specific CT‐based musculoskeletal models were between 54% lower to 45% higher from those estimated using musculoskeletal models adjusted only for subject height and weight. The impact of subject‐specific information on vertebral loading estimates varied with the activity and spinal region. Vertebral loading estimates were more sensitive to incorporation of subject‐specific spinal curvature than subject‐specific muscle morphology. Our results indicate that individual variations in spine curvature and trunk muscle morphology can have a major impact on estimated vertebral compressive and shear loads, and thus should be accounted for when estimating subject‐specific vertebral loading. © 2017 Orthopaedic Research Society. Published by Wiley Periodicals, Inc. J Orthop Res 35:2164–2173, 2017.
17 March 2020 in Water Resources Research
A novel statistical approach is developed and implemented for the stochastic reconstruction of nonaqueous phase liquid (NAPL) source zone realizations and the quantification of source zone metrics and associated uncertainty. The approach employs discriminative random field (DRF) models, to simulate the spatial distributions and relationships among source zone properties (i.e., permeability, NAPL saturation, and aqueous concentration distributions) consistent with commonly collected field data. Application of DRF models requires a limited number of full‐scale simulations to train the model parameters. Monte Carlo sampling methods based on these trained models then provide an efficient method to generate contaminant mass realizations conditioned on measured boreholes, bypassing the need to run computationally intensive, partial differential equation‐based simulations of physical flow and transport. Postprocessing of these realizations yields approximations of uncertainty to inform further sampling for characterization and remediation. The reconstructed contaminant mass realizations provide sufficient information for calculating averaged characterization metrics, such as total contaminant mass and pool fraction, used to predict source zone longevity, mass recovery behavior, and remedial performance. The model performance is evaluated through comparisons of these predicted source zone metrics with those obtained from the “true” mass distributions generated with validated flow and transport models. These comparisons clearly demonstrate that stochastic application of a DRF model can reconstruct realistic saturation and concentration fields, conditioned to borehole data at different times. The present study should be viewed as the first step in generating a three‐dimensional characterization tool that can be applied over a wide range of conditions observed at contaminated sites.